carb

Hello Can anyone tell me what kind of carb is this [attachment=2:13iq9emv]26306760_10-carburador-barato-Leiria.jpg[/attachment:13iq9emv] [attachment=1:13iq9emv]26306760_11-carburador-barato-Motociclos-Scooters.jpg[/attachment:13iq9emv]...

First frosty ride on a Berg this morning and it cut out. approx minus 2 degrees Celsius The bike started up great at the car park, idled and was off choke before I rode off. 2 miles down the road I turned off the main road and it cut out. It restarts then cuts out immediately,I repeated this...

I'm slowly getting to know the new to me 2008 FE 450 and in general I am happy with it. It is the first Berg that I have had and the first euro dirt bike so there is a lot to pick up and I have been trawling through the Doc which is huge compared to what it looks like at first glance. One of...

Gents, Got a mate that has an 02 FE 400, he wants to do an upgrade to his carb, seems he's thinking Kehin. Is this any easy thing to sort...?, has anyone done it that can offer advice or experiences. He's tried the jetting and it's improved but he's still not happy with it. Figures...

I recently got a 2003 400E model from the local Husqvarna dealer (in Romania, Eastern Europe), the bike was not running, the stator was shot, the local husaberg shop change it with a new one, and the bike run, but was suffering from poor starting, in the way that when cold it felt like the...

I have a 97' FE501 with the PHM40 ZS carb that is running way too rich for my altitude (I live in Colorado at about 8500ft. above sea level). This is the second year I've had the bike and it ran OK when I first got it I had to turn the mixture screw all the way in, and back off the idle screw to...

Hi I have a 1997 fe 501 starts perfect half a kick no choke, but in higher gears it 3/4 to full throttle it start bucking and missing. It is using a lot of fuel and seems rich at idle plug is black. I am thinking about lowering the needle. I also have a 38mm Keihin carb off a yzf250 laying...

I sent my carb off to be rejeted and had a good race out the bike and left it for a week and then it would not start. Coolant in the oil, slipping sprague. Repaired all that and it still would not start. All that was left was the carb, so I removed the float chamber and I found a lot of what...

Hi All, I`ve a FE400 with a Dellorto PHM 38 carb if i was to change to a 40 carb would it make any difference and what differnce would it make :?: :?: Cheers Bob.

As i read some were on this site all husaberg come jetted to rich from the factory. I have decided to try to jett my carb to get better fuel economy, and do the BK mod. This is what my carb has in its gut. 160 Main 200 main air (MAJ) 45 pilot 100 pilot air (PAJ) fuel screw 2.75 turns...

Hi all, I`ve a 2002 FE400 and i am after upgrading the carb on her after many a problem with flooding, jetting, starting etc. What carb do i need :?: :?: :?: :?: :?: Thanks , Bob.

I have the above bike 2002 with the dellorto carb, the problem i have with it is after binning the bike, the carb floods it appears to have an over flow tube which is not blocked but the carb bowl does not drain. What may cause this? Any advise/info is appreciated Thanks Bob

hi there, my fe600e runs like it has a powerband,it seems to die and even backfire slightly sometimes at mid revs then it takes off like a bullet,i have disassembled the carb and blown it out with compressed air a couple of times but it still does it,sometimes worse than other times,it also pops...

Just got a semi-disassembled 99 FE600 on the cheap. There aren't any hoses on the carb. I have the fuel hose and fuel pump hose connected but not sure where the others go. I'm pretty sure the small hose barb aiming down is a fuel overflow line but where do the two brass ones on top go? Thanks!

Hello. Just started my 400 -00 with 501 FC exhaust system. The bike won`t run on higher rpm`s just popping and hesitating. Floatheight is ok. Have new Dr272 and K51 Tried PJ 33, 35 ,45, 55 MJ 175, 180, 185, 195. SJ 45 Tried needle in all positions With the MJ 195 and PJ 55 and neddle in...

ok taffy, i probably should have researched this but my 02 470 with an fcr runs great thanks to your jetting lessions but it doesn't hot start too well. i forget what's in there but i followed your recomendations. i recall i couldn't readily find a small enough pilot so i set the PAS...

hi ! i am about to convert from dellorto to keihin fcr 41 on my 650 .. but i reconized that the fcr has got i manuel choke wire. watch this picture. i woundering what i should do whith that ?

I would like to know the model of my carb on my 97 501 fe, so I can go to Dellorto website and look for some parts. If some one knows a good site for carb parts & everything else for the make of the bike I would greatly appreciate it

I have a 2001 FC 550. Took a spill this last weekend and the bike flipped completely over causing oil to fill the carb. Has anyone had this happen to them before? How did you go about cleaning the oil out of the bike where oil should'nt be? Hope I don't have to tear the whole bike apart!

G'day, I'm now questioning my earlier decision to plumb all of the carb breather hoses into two final outlet hoses, simply using hose tail 'Tee' fittings, purely for simplification. If there are certain hoses off the carb requiring vacuum for any reason, plumbed inline with fuel vapour/...