carb

Some years ago I had a 1996 FC400 but gave the bike away to a guy in Michigan. Digging through an old toolbox I found some old carb jets and a needle. I believe the carb was a VHSB 38. If they are useful to anyone, please feel free to email me at [email protected] - they are FREE if...

Hi all posted a couple of threads about this bike but striped carb of today and don't think it's the original carb I could be wrong it's a delorto vhsb38 with flat slide I'll post pic

Hi there been out on the bike a few times since I got it runs great but seems a wee bit leen top end not much the plug is clean and there is no black smoke from the exhaust ever is this good or should there be a bit ???? If I need to riches it up can I lift the needle or do i need to get jets

Hi all sorry for all the posts but just interested in moding and tuning the berg what would be the hp difference of the flat slide kh over the delorto carb that's in the bike standard ?;)

hello all, I just bought a 1997 Husaberg fe400 and its a blast to ride. the bottom end has a ton but once I get half way through the RMPs it starts to bogged down really bad.... I am new to Husaberg so I don't know much about them mechanically. my guess would be these bikes are geared low for...

Hi all new on here just got my first Husaberg and it's a hoot only thing I wanted to do was set the Carb up what is the standard start setting on the air mixture screw On the carb and I can work from there :)it's 1993 model

Okay so I have two "buttons" or "levers" on the carb, one red and one black, the one I bought the bike from told me the red one was choke and that he had seen the black one, that tells me he wasnt really experienced so he cant be trusted. ;) Well, I know that one is choke and the other one is...

Hi. Does anyone know of the PC Racing carb vent system/box? I ordered it and it arrived in the mail, so I installed it and followed the instructions step by step and double checked. As the instructions stated, I connected the middle part of a 'T' piece to each of the 2 side vents of the carby...

on the fs600 dellorto carb there is 2 upward pointing pipes.what connects to them?

Keihin 41mm FCR Pilot 45 Starter 85 Air screw 1.5 turns out Good starting point? These 3 air screws were in box of carb spares, which one should I use? Where in the UK can I get parts for this carb? Many thanks

If I lay my bike over /flip my bike and stall the engine, it is impossible to start. What I've found is fuel leaks into the inlet elbow prior to the carby, it does not need much to prevent starting. So I have to remove seat, air filter and soak up fuel with a rag then reassemble. It generally...

YU7FE3500R0000127 I just bought it im lookin for a carb for parts or a whole carb

Hello all. I'm fairly new to Husabergs, and when I got the bike it had a seriously high idle it would start within two to three kicks. I had the valve cover off to tighten the timing chain tensioner that had come loose. I noticed that where the choke line fastened to the carb it had backed its...

My first Husaberg and i think the first delorto i've ever messed with. (96 501) It doesn't want to start without priming it. Carb is clean although the slide is kinda loose.It has auto comp release, i don't much care for it although it works like it should...It will get set up manual later...

Hi everyone, I've just bought a 04 fe450 with a 380 kitted fitted. The bike starts sweet but on the throttle she feels a bit boggy and when revv'd quite hard it will smoke a bit and shoot the odd flame out. I know the carb hasn't been touched ie jets/needle position since the 380 rebuild and...

Finally bought the Keihin Carb I mentioned :). Wish me luck, this weekend I'm mounting it on the beast :D. Tom

Is this possible? I'm taking my carbs apart to clean them following the manual I was given with my bike. Has been fine so far up until this part: "Unscrew the idling jet (4), starting jet (5) and needle jet (6)" But in my carbs at the location of (6) there is nothing to unscrew like there...

Hey guys! I noticed lately my bike will leak fuel out of the drain on the back of the carb after i shut the bike off. Sometimes it doesn't and other times it leaks pretty bad. So would this be caused by the float sticking? I've never had a carb torn apart so i am a little hesitant on doing the...

Hello, I restore a problem that I mentioned some time ago. I have a FE 650 '01 and I need everything I write in the Subject! The carb and the ignition coil and rectirier missing. The stator after checking with multimeter seems to have damaged! I received an offer from the company HPI Horse...

Hi All, I'm a new to Husaberg rider. Recently purchased a 98 FE600. I grew up riding dirt bikes in NSW Australia, but have been more in to street & dual sport bikes for the last 15 years. I finally came to the inevitable conclusion that there really isn't a dual sport bike that "does it all"...