pump

hi i think the vacume pump on the 501 i got as a project is knackerd any way to bench test it ? thanks in advance john

So, my fuel pump is bad on my 2011 FS-570, rolling $$ eater. Does anyone know of an aftermarket pump that will work on this bike? The OEM is like $520. I just want to make sure there is not a cheaper solution out there b4 I crap out that kind of cash for a new pump. Thanks FT

hi all just rebuilding my 2008 450 with the help of taff . thanks mate left on my own putting the water pump pin in i dropped the pin and it dissappeard in to the water jacket and pin is made from ss steel so magnet would get it out any ideas ?

hi guys.i bought my first berg a few wks ago.550fe 2007.but the coolant is coming out the weep hole so i bought the o ring,seal,gasket and bearing.i took all apart today and im havin difficulty getting sorted.can any one tel me exactly watvto do.i have the new bearing in the cover an its sitting...

Hey guys. Ive got a fx 450 2010 model that i really get to enjoy. I had a fuel problem a few months ago and replaced the fuel pump and it ended up being a fuel pressure regulator! Yeah. I wonder how many peeps have ran into that problem! Anyway, i was riding with my nephews holding...

Hi all. Looking for some advice on wiring issues (2010 FE450). I've just had the dreaded dead fuel pump failure, and it was definitely the pump as there was power to the plug but it wouldn't run when hot until it cooled down again. The pump has just been replaced and it was fine for the first...

I have gone through hell and back trying to get my '09 FE450 to run. Turns out it was a bad replacement fuel pump. I am posting this to as a quick 5 minute way of finding a bad pump, perhaps saving some poor soul the aggravation I went through. Simply remove the fuel line from the fitting at...

Hi People, I pulled apart the fuel tank and need to disconnect the fuel pump from the hose's it's connected to, I have disconnected the positive and neg wires to the pump, but the hoses look like the are heat shrunk around the barbs on the fuel pump. I tried to pull them off but dont want to...

Why would my 550 blow the radiator hose off of the water pump housing? the first time was when I didnt get a full kick in on it I accidentally gave it a lil gas when kicking it, this resulted in me nearly getting thrown over the handle bars and the radiator hose? getting blown off the water pump...

Does anyone know if there is a high flow pump available for the 570? The plastic impeller is cooked on mine and I would like to replace it with an aluminum one like Slavens sells for the 2 strokes.

I'm doing my regular maintenance on my 2005 fs650e. I have always installed the water pump seal with the spring on the inside. I have never had any leaking problems. I read somewhere that the spring on the seal should be facing the impeller. Just wondering how everybody else installes them...

Has anyone taken one of the new KTM fuel pump systems and used the pump to swap out your failing pump? I have got a 10 570 that the pump has started seizing up when hot just like all the others. I have a got a line on a complete KTM pump setup but it is very different overall design. The pump...

Hello Group, So what am I doing wrong. 1. Ca-Cycleworks pump arrived this week. Fuel nozzel is 1/4 inch not 5/16 inch as others have said. 2. Others have said use Napa H209 submersible 5/16 fuel line with 13-15 mm FI rated fuel clamp. 3. The NAPA 1/4 submersible fuel line is apparently H315 and...

I have problem witch fuel pump in FE 450 Mod 2011. someone got one solucion? Thanks

was changing oil on my 2010 fe450 that has 15 hrs an found a cut in half stop disk an a hole tab washer on end of the magnetic drain plug part # 21 and 22 on page 20 of our spare parts manual:engine. anyone have this issue or anyone know what what it will take to get inside there to fix an...

Hi Guys, I dont mean to start a new tread about the same thing but just wondered if people were still having problems with fuel pumps, even on 2012 FE570's? Ive had my bike for two weeks, 5.5hrs. Installed a akra carbon slip on, and a few days later the bikes playing up like a second hand...

Hi There, Sorry for the stupid question but I am mildly confused on this one, I have changed many a seal on the KTM RFS engines no problem and figured this was the same, hoping you guys can help me out a little? I did search forum first but not quite getting it. I have a 2010 FE450(and one of...

This pump is on a 2011 ktm350 probably what is happening to the pump on the bergs.(the 2010 and 2011 i have owned have never had a problem just thought i would share the vid I found) http://www.youtube.com/watch?v=sedEgE_BK2k&sns=em

I've been having some problems with my 2010 FX450. It's only got about 4 hours on it. Last weekend, after about 45mins of riding, I stopped for a second to wait for my buddy to catch up and when I went to start the bike it fired for a second and then died. I tryed again and it just cranked. I...

Hi, How to open fuel pump hose connector(s) on 2009 FE 450? I'm replacing the fuel pump assembly, and simply by pulling, twisting or slightly pressing the round(ish) connectors I cannot get the hose connectors to open. Trying to avoid excess force and not to break anything in the first place. I...