pump

Hi, I'm from Spain, and this is the only Husaberg forum I've found. First, excuse me for my English. I think that in this section of the forum, I have the right solution for my fault, since it seems that the bike's failure is electric. Excuse me if the subject has been discussed in another post...

Does anyone have the fuel pump housing from one of the 10'-12' bikes? Maybe someone who replaced theirs with the aluminum version used for the subframe tank? I believe these may also be the same on a number of of KTM models.

looking for water pump cover for 2014 FE 350...help

Hi guys i have a fuel pump relay flash come up and no power to the fuel pump pin... Where is the fuel pump relay located please? I made a jump wire to power the pump to get me home today

Hi guys im new. Took my 09 te 450 for a second ride and the fuel pump stopped and i got 4 long and 1 short blinks. Put a multimeter on the plug and 12v but nothing will a test light... i assume dead ecu?? Wires carry the load fine, pump is fine. To get home i put a jump wire into no1 fuse and...

Hi, after riding my Husaberg FE570 for about 2 hours yesterday it started to run lean, I tried to fix this by redoing the Grease around the air filter seals. After that the bike seemed fine again, but after about 1 hour it started to fuel cut and sputter/back fire :eek: After stopping the bike...

Hi, I belive my fuel pump has retired a bit early, as usual on these bikes:unsure: Today was my first day riding the bike after i got my license, and i have been counting down to this day for a month now, so im quite bummed :cry: At first the bike ran fine and normal today, after about 2/3...

Hi guys, was out riding over the weekend (about 80km) when I shut the berg down. It was off for less than a minute then tried to start and it would just crank, took the seat off and tried to start it to hear the fuel pump and nothing. I have checked all fuses in the fuse block plus the Yellow...

I was wondering if owners in the know can confirm and/or recommend what steps/actions I should do. I went on the ride yesterday. It wasn't too hot out and I was riding maybe for about 1.5 hours. A few time I felt like the bike cut out temporarily a few times at close to idle speed when I was...

So the engine is splash/bath lubricated. Primary gear, clutch, idler and kick gear on the left side of the engine, in oil bath. Gearbox on the right side also in oil bath and oil can flow freely between right and left side. Cam, rockers, valves gets splash lubed by the oil carried by...

Looking for some possible help here, I'm the original owner of a FX450, which developed a hard to no start problem. Now it's no start after sitting for a year. Drained gas, nope Valves, nope. Spark Plug, nope. Battery, nope. Replaced the fuel pump (3nd one) nope. It's...

Shaft is scored and is leaking coolant. Can I replace the shaft easily ? Just the right side cover? Or do you have to split cases?

I have a subframe tank without any of the hardware and wanted to see if anyone knows where I can find either the hardware or dwgs/CAD files of the parts. I can machine parts at work with a CNC or TIG weld if needed. Thanks

Hi all, Have a '09 FE450 which wont start: 1. Checked spark - seems ok (have not removed plug, just checked on engine casing) 2. Checked fuel pump - pumps fuel OK (have not checked pressure but it primes & pumps when removed from tank) 3. Checked injector (removed & cleaned, can see it...

My 09 fe450 runs fine from cold but when when it gets hot (Boiling rads hot) it starts to stall in low revs, like the kill switch has been hit for 1-2 seconds starts to die in low revs. Today when out and the bike was warmish I stopped and it would not restart for about 30 seconds just had...

I'm original owner 2011 FE570S, 3300 mi, 178 hours on original pump. Bike was built with the "corrected" injection pump. Came back from successful Colorado trip, changed oil, etc., washed bike, started it till warm and put it away. Getting ready to go back to Colorado, pushed the button...

Hey! I've got a problem with my Husaberg FS 570 2010. I had been out and run for an hour, suddenly dies. Drove up to the edge and tried to start it. Nothing happened! When I start looking, I heard that the fuel pump went and the smell of gasoline. I pull out the plug to the main relay. Then I...

So, going in again to change the pump seal and have a question about how deep to send it into the cover. Do I need to only drive the seal until it's flush with the cover, or until it seats against the oil seal? Last time I did this, via 3 seals later, I managed to seat the seal flush with...

Riding my 2011 FE570 going off a small jump engine had a small pop and died. Lucky for me it was at the top of the mountain costed the bike for about 3 miles push it for only about 500 yards before I met up with friends. Later tried starting it nothing but could hear pump working (sounded a...

G'day all. Just changed out both water pump seals, oil/coolant, on my 2009 Fe390. The coolant seal was straight forward but it wasn't quite clear as to wether the oil seal could be replaced without removing the housing. It can be done. Carefully. The oil seal is backed by a bearing so there is...