problems

Just got back from a great ride in the peaks but half way through the day my bike suddenly lost all of it's top end power and was cutting out. Was also misfireing. Bike has only done 10 hours. Haven't had chance to strip it down yet. But was going to drain the fuel and clean the fuel pump. Any1...

I am having a problem and cant figure out what is causing it. It's a FE 390 2010 model, stock clutch, rotella oil, the hydraulic parts have been bled, back bled, forced bled, first with magura oil, then trans fluid. The bike has 900ish miles on it, oil change every ride, filters every other. The...

Hi! I'm new on this forum, so at first I would like to say HELLO!!!! :) I have a problem with my FE501 Berg (2001). I have just mounted e-starter with brand new battery. Engine starts "from first kick" (cold or warm), but I can't start it from electric starter. After small investigation I know...

I failed to Finnish a race today due to a flat battery :cry: Started fine this morning and stalled a few times but it always fired up. Then 40 minutes from the end stopped the bike to take a drink, hit the buttern nothing! Let the bike cool off, still nothing. Checked terminals. Put it on...

Just thought I'd drop a line to tell you about the valve sealing troubles I seem to be getting when rebuilding engines. I often didn't used to have to worry about valves sealing on the exhaust side but in recent engines it has been virtually every single one! lapping the valves in, I find...

Hi all! So, I was admiring my nicely idling berg one day. And I couldn't help playing with the idle screw, well I managed to set it so low that it died. Haven't started since. And now I was trying to fix the problem and after I removed the sparkplug few times I totally lost compression. Any...

Hi, just registered to the forum as bought husaberg 650 02 couple weeks ago, have some problems and cant figure out. when I bought it wasnt used for a long time so I couldnt start it , only pull with car can start it, after that I cleaned up carb, fitted new spark plug, adjusted valves, then...

I need to find someone that can flash my ecm without the bike. I recently bought a leftover 2010 fe 570 usa and from day one I have tried to get the service dept to flash the ecm because it was running way too lean. They ensured me they could do this and after they kept putting me off for 6...

I want to weld a sidestand bracket onto my 2002 FC550. Any cautions or recommendations when it comes to welding on the frame?

ok hear goes. i installed 24v system to starter it flat works. i have tested it and not one problem. this bike starts every time cold or hot. i can charge both batts with flip of a switch i have put more hours on bike so far this season then ever before. its ajoy to start. i have done this same...

I just got a great deal on a fe 2010 fe570 but the dealer has only been selling husabergs for a couple of months and the service dept doesn't seen to know that much about them. I have a few concerns about the bike and hopefully someone can point me in the right direction. The bike has 1.4...

Hey, I installed the jd kit for low elevation and now my 41mm keihin is overflowing like crazy when I turn on the fuel...any suggestions?

Hi have just joined site. my berg will not start had SEM & coil cecked by Taffmeister and ok. Have remade new loom as was in poor condision. good spark and plug gets wet (so fuel) But still will fire up.please any ideas many thank Keith

First frosty ride on a Berg this morning and it cut out. approx minus 2 degrees Celsius The bike started up great at the car park, idled and was off choke before I rode off. 2 miles down the road I turned off the main road and it cut out. It restarts then cuts out immediately,I repeated this...

My first question is where is the bloody kick starter and why weren't the Husaberg designers there to help me push start my bike . Yes I have done the valves ,helped a little . Yes I have a new battery didn't help Jump started off my car ,worked once. When trying to start the starter motor...

Hey new to this site, and also new to the bergs, bought my first dirt bike ever and have a 98 fe600s, been out on it 4 times, did my first poker run, i love this bike but iam trying to get a stock pile of parts to complete a full rebuild this winter, does anyone know where to get them, iam going...

Got rained on pretty bad the last two rides, and both times the bike wouldn't start with the electric leg anymore when everything was saturated. It's an 08 FE550. When I pressed the button, water was squishing out of it, too. Haven't seen that before. Lights and all worked fine after the bike...

hello, i'm seriously considering of selling my FS 570 because i'm having alot of problems with it :cry: i bought the bike new in august '09 and after a few months i've had a starting problem (wich was fixed under guarantee after a lot of BS) i have 5200km on the bike now, i turned it in at...

I am having trouble with my electric start it wont.It will turn over but its really slow.i have replaced battery and checked my valves which are fine.Starts ok with kick start but is tireing any ideas.

Hi, I have been having some problems with my FE400, It was running fine but never was able to start it on the kick start. Anyway it started ok with the bigger starter motor and ran fine but then it cut out a few weeks ago, checked the stator and found out that had gone. Replaced it, now there...