stator

So before i just start looking for one though it would run my problem past the husageniuses.... 1st off bike ran great all last fall on the road and winter in the feilds, i noticed the last time in the feild before i took off the knobbies one quick stutter at low rpm slight acceleration and...

Hello This is my first visit on this forum. I was referred here by a Husaberg dealer. Any help I can get is greatly appreciated. So here we go - I just purchased a 1996 FE350. I was told the stator was probably bad, but I think I got a fair deal on the bike so I went ahead and bought it. Now...

Hi Am new to the forum, and to Husabergs, have just bought a 2003 FE400 fitted with a Electrex stator. The bike is running fine, but am concerned after reading conflicting reports. Have seen posts advising fitting a Zener diode (280v and 3W) between the red power wire and black earth from...

hello, my SEM stator on my 03 FE 400 is dead :( now I looks for new ELECTREX stator, is it good choice?? Does anybody ride with this stator?? I´m waiting for your opinion :)

hi all just thought i would post and see what people thought iv been toying with the idea of desighning a new sem safe stator well over the last few days iv put my thoughts down on paper and came up with a stator thats sem safe and a direct bolt on replacement iv came up with a desighn were as...

Just to let you know that I had a customer in yesterday who had had his stator repaired elsewhere here in the UK by someone using an ad on ebay. although all the figures were good the stator just wouldn't spark. minutes later - and with a sparks stator fitted it was a runner! I know sparks...

got a 2003 fc550.its been running great all summer.starts one or two kicks hot or cold.i brought it back home from where i ride and gave it a good clean.i started it up after the wash and it ran perfect.i left it a couple of days then went to start it and this is where the problems started the...

Okay, Been sitting on a 99FC400 with a bad stator. (sitting because that is all I can do with it unless I want to coast down a hill). Anyone got one for sale. I'm pretty sure any 99 to 03 model stator would work, not counting electric start models. ANYONE got one for sale.

hi all who is best to send my sem stator to for a rewind off a 03 650 fe and how much thanks

Hi guys, I am new to the forum and I need a little direction/help. I currently have a 2002 Husaberg FE650http://www.webboxmedia.co.uk/toys.jpg A friend was riding my bike and it suddenly cut out after reading the docs etc it seems it was my SEM stator. I tested the values...

Hi from New Zealand,Iv recently purchased a 2001 550 fc,apparently its had the fe wiring loom put in it and electric start etc,anyhow the stator crapped itself on the old owner,he brought what is apparently a rewired stator from overseas and installed it,(it actually has 470 fe written on it...

1998 FC400 with bad stator black/green 165ohms, Black/red 200 ohms. Can I swap in a 2001 FX470E stator? Do I need the flywheel as well? thanks

Hello. I have a 1992 husaberg fe 350 in which the stator is dead. Now I have quite similar stator from a 125cc aprilia. I measured it and it gives 1,7 kOhm from red to black and 60 Ohm green to black instead of the 23 Ohm it should be. I'm not getting spark with this aprilia's stator and I am...

Help needed, electrex stator source coil resistance reading 440 ohms what should it be ? 3000 ? anybody know ? bike emitting very weak spark..suspected sem ignition coil..sent off nothin wrong with it (thanks Taffy ) sent back again...runnin tests now..suspect ignition source coil eh ? ...

need a stator. I'd like to add the flexability of lights if I chose to go down that road in the future. Poked around and looked like a KTM 400LC4 is a direct swap as long as I use my cover. What other options are there. Going to contact RM Stator as well. thanks!!

anyone fitted a KTM stator on a Husaberg? does it run OK? regards Taffy

Hi guys my name is bruce and I am new to this terrific site. I have recently purchased a husaberg. I do not know the model or year. Its a 600cc single and from the pictures ive looked at seems to indicate her to be circa 1995ish. The previous owner said It would only run with a push start. But...

i am redoing a rat "00 fe400e and after reassembling most of it, i find i have a bad cdi. this cdi is the same design (digital force?) as the '99-03. difference is the connectors. good guy that i am, i sold my spare cdi of that vintage to brucifer a while ago, so i'm out of stock as it were...

Just received an upgraded stator from Taffy and installed it, and get no juice. I have stripped it down to the plug from stator wires to the coil, ground for the coil, and spark plug lead. No spark. The R-B ohms are only 2600, is this possibly the problem, or am I looking at a bad coil? What...

I Sparks Could you please tell me if is possible to convert one FC stator (only three wires) to the one that can charge batery ? Is it economical iteresting ? Thanks ZAGA