starter

Did the 06 fe650e have an issue with the starter clutch because mine sure does. I've owned it for about a year and had all new starter clutch parts put in. It worked pretty good for awhile and got progressively worse until it doesn't engage at all. Is there anything that will solve this...

Got a 1997 fs600 kick start model. Renewed all fuel pipes, cleaned out carb and jets. Getting a spark from the plug but will not fire up??? Noticed a small crack on rubber inlet manifold so sealed that up(and ordered a new 1) but still nothing?? any ideas??

Getting to the end of a complete teardown and rebuild on a '00 FE600. Replaced the sprague with a new one from Taffmeisters, put the engine in and realized the starter is also bad. Looked high and low on the internet, tried to match it up with anything and everything and came up with nothing...

The starter motor in my '05 FE450e has given up the ghost. Anyone in Australia have a good one they want to sell or know where I can get one? They are nearly $500 new from Husaberg!!!!

hi, i have an 01 400fe with a 501 engine in it ... the bike will start on the first or second kick always but i cannot get it to start on the starter motor ... heres what ive tried so far. all by following the manual fully charged battery, set ignition timing to factory spec ..set valve gaps...

about 4 years ago I found this amazing web site in the USA. no colour, just word script describing every starter motor ever known to man for a motorbike! it also had pages on stators, on condensors, points etc etc. I've searched ahigh and low ever since and can't find it? the...

my 05 450fe started a strange rumbling sound around clutch. pulled motor down couldn't find anything at the start but found the four small needle roller bearings holding starter gears look fine but when put gear in a turn by hand it sounds like rollers in bearing are square. can anyone give...

Dose any one know where I can get a kick start shaft because mine have snapped or a full starter motor set up ... I can get a full starter motor set up with all cogs and wires off a fx470 2001 the parts look alike but I really don't plz help thanks luke

Hi guys Can some body tell me if this is correct for wiring from battery to the relay then to starter and earth from battery to frame as I've done this and it is still not turning starter over ?

hey guy's, some help would be great , the clutch has gone in my starter motor , i know this because i spoke to the mechanic at dave clarcks ,i suppose my question is how dificult are they to fix as i dont have a manual for the model of bike , i'm not bad with spanners just need a few...

I am in need of a replacement starter motor for my 1999 FE400E and dont want to go to the expense of a new one and cannot get a second hand one. Do any members know if any other models fit as I tried a different one and it was too short and the output shaft diameter was too small. Most of the...

Hi guys, im the proud owner of a Husaberg FE501 2003 model. I have no spark and my starter motor is not turning the motor over, it's making a slipping noise and then grabbing every now and then, I removed the starter motor and the teeth seem to look fine. I have tested the coil and can confirm...

2005 FE650e, 140 hours. Dropped it on the trail (irrelevant) and when I picked it back up the starter worked fine. Rode 1/2 mile to the road and shut it off to wait for the stragglers. Went to start it and nada. (silent, no click) Kicked it and rode on, then shut it off next intersection to...

I've been trying to get the e-start to work on my 650, mainly cause I had some knee problems after a "nice" fall and I've been having a tough time kicking it in, so I ordered a yam r6 starter from e-bay. Fitted it, hooked it up to a car battery since the original battery is small and had gone...

For some inexplicable reason I'm contemplating removing these from my bike, 1. Too bulky 2. Looks messy 3. Old school. Can someone please talk some sense into me. Look how tidy: http://motoprofi.com/motospecspictures/ ... -2007.html

I was getting the whirr sound when pressing the starter button. So I've just fitted the 'Starter repair kit' from Taffmeisters. My Mrs wanted to know what to get me for valentines day, well it beats a card! I ended up using both shims to get the torque high enough. All in all, took me around 3...

I have a PDF of the service manual for 1999 Husaberg FE501 and i had come across a section on the electric starter. i am currently looking for one that would fit the bike, does anyone know where i should start? the manual doesn't give me any specifics on what brand or size to get.

I have little problem... Today i use a lot of electric starter ( i use new FCR 41 and change jet's ) and now he's broke... Don't work. I mus take new, but i don't know what is name of electric starter. Know everyone what's name? Specification? To fe 400 can be from r6 or cbr 600, but to fe 501...

Hi. My 2005 fs 650e has been having problems starting with the e-start when the engine is cold. the stater just spins and when the engine is warm no problems starting. I removed and disasembled the torque limiter gear and I found 2 cup washers instead of one. should I remove one and install a...

Hi new to the forum. Can anyone advise me where I can find a husaberg starter relay. Mines packed up, I was hoping to have the bike running ASAP. Are they used on any other make of bike? Bike is a 400 fe on a 53 reg plate, and I'm in Kent. Thanks