pump

Thought I should post this info for those who have a leaking water pump, as it seems to be a common problem. If you have oil or water leaking out the weep hole of your Berg, there is a kit available to fix the problem. Local Husaberg/KTM dealer in Orange NSW Australia John Prior, has produced a...

so i got 10 hours on my 03400 now. bought it last month with zero hours. is the position of that weep hole a design flaw? i got some oil leaking out now (no big deal - just a few drops) but that weep hole is pointed in a direction that is perfect for catching sand off the front tire??? Does...

I searched this forum but couldn't find what I was looking for.... I am new to bergs, but not bikes. The stated CR for the bike is 11.8:1 and while quite high, I feel it should run tolerably on premium pump gas in a street/play application. My SMC was fine on the pump stuff but I realize the...

Having asked al lot of questions during the last month about the conversion of FE550S 2004 into supermoto, i finally succeded my target. the only thing that i didn't calculate right from the begining, was that i had to change also the brake pump. the caliber remained the same (brembo), i put...

Hello everyone I have a 1993 Fe 350. Had a bent rocker so I purchased a used rocker cover.It had the 12mm rocker shafts instead of the 10mm mine came with stock. The casting numbers were the same and it fit. Now that I am ready to bolt on the cover I see a difference. It appears like the top...

Why is there a difference in the height of the stop located on what would be the bottom of the fuel pump diaphragm? I recently replaced mine when I put the quick shot cover on as per the directions. And the replacement the local shop had a significantly longer stop than the stock Husaberg...

Hello all. I just got both seals that go on the camshaft from Dan at Motoxotica for my 99 FE501 but I am having trouble installing them. I noticed that the seals I pulled out had a rubber outer surround however the new ones are steel. Dan says that the ones he sent are the current...

Perhaps one of you can help me diagnose my newest problem with my 600. I was out for a short ride up the road with the beast when it backfired and lost all power. It didn't die, but I had virtually no bottom end, and no mid range. When I opened the throttle it came on in the top end and just...

Research did not reveal any info on this item so please excuse if this has been hashed over already. Has anyone tried or had experience with the Boyesen Quick Shot Accelerator Pump cover for the FCR Keihin?Supposedly this supplies fuel to the motor in greater volume and with more velocity during...

Is the fuel pump on a 1998 FX 600 rebuildable? If so, where can I get a rebuild kit. My local dealer tells me that I must buy a new pump.

Where can I purchase a De'Orto fuel pump? thanks Ken

hi, just read some facts about the Taffy mod and BK mod on the acceleration pump of Keihin. Some people (Dale) disabled the function of the pump completly. YAMAHAs and KTMs are known to react very well on the mods, but what about the Husabergs? What is the estimated squirt duration for a FC450...

I have been musing on the technicalities of engines with a few people recently as I often do. We were trying to figure out why trochoidal rotor or gear type oil pumps are used in modern racing engines with roller bearing big-ends/?? Bearing in mind the following: Oil pressures are...

All, I am in discussion with dan from motoxotica, there seems to be a bit of confusion on my part, (go figure) regarding the seal or seals that are used. On my 98 fe600e there were two seals that prevented the mixing of oil and water, When i disassembled the water pump and removed the...

What are the procedures to bleed air from a PDS rear shock using the 'hydraulic pump motor'? 1. Where to connect the pump discharge hose, on the rebound hole or the high/low speed hole (I have the adapters)? 2. Others air bleeding procedures that must follow... Thanks. :o

Anyone know of a water pump impeller for a 00 FE400E made of something other than plastic? Thanks in advance, husadawg 8)

I saw an 04 450 today with the water pump cover broken. I think I want a few of those guards. Any idea who sells them? I had heard Dave Clark Racing has them in the UK. Anybody have any input or perhaps a web address? The guy with the 450 says he has a KTM 450EXE and prefers the Berg.

Hi, Is it possible to use a diaphragm accelerator pump on a dirt bike? I have only seen piston-type accelerator pumps. Since it seems to be good for the functionality for a big four-stroke, why isn't it used with the Dell"otro carb?

While riding slow technical woods at high altitude my radiator hose popped off the water pump neck. I noticed the barb is a very small dia. to keep the hose clamp from slipping past. I am planning on welding a bead around the end of the neck and then machine it down to clean it up while...

Hope someone can answer a few questions for me. I went to buy a new 2004 FS650E yesterday. The dealer started the motorcycle and after letting it run for a few minutes oil started dripping from the "seep hole", or "pin-hole" at the water pump assembly area. 1-Why is there oil leaking from...