engine

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. H

    For Sale FE650 engine swap into older husaburg 97 501 possible?

    FE650 engine swap into older husaburg 97 501 possible? Got a Ca plated 501 that is tired & I am tired of kicking it. This would be a nice solution vs rebuild and live with kick starting. The extra 30% power...Bonus! Wondering if it drop in easy mod or don't attempt Anybody know...
  2. I

    hardware left over from engine assembly

    2008 FE 550 Can anyone verify where the hardware in the two pictures belongs? I've just recently finished assembling the engine after it being apart for quite some time and cannont exactly remember where these pieces of hardware belong. I did follow the instruction manual very closely...
  3. T

    Cold engine issues

    Hey still pretty new to the world of dirt bikes and recently my 05 fe450 started having issues starting up it didn't have before. It starts up fine but if I try and give it any throttle before engine is warm it dies. Haven't been able to figure out the reason would love if anyone has some info...
  4. S

    2009 FE570 Engine Noise / Squeal

    My first Husaberg and first dirt bike. Was wondering if this noise is something to be worried about. Bought it about 18 months ago with 25 hours on the clock and has about 40 on it now. Oil just changed (but not for the first time). Thanks!
  5. F

    For Sale 570 Engine wanted

    I am looking for a 570 engine. Mine has a hole in the case that I can't get to seal.
  6. S

    For Sale 650 supermoto engine

    For sale 650cc supermoto engine out of Dave Clarke,s own bike its had new liner, piston, conrod, etc 4 hours ago. I bought it for a spare motor so never used it, Electric starter fitted £2250 ovno I cannot upload any photos but I will send them to anybody who needs then
  7. V

    07 fe450 fell over now engine will not turn

    Desr Husaberg forum. Yesterday was out with some friends doing some forest trails.. slow easy pace.. at one stage i lost balance and droped bike over left side. Being quite a steep hill the bike was almost in an upside down position. Bike is an 2007 FE450 Picked her up, tried the e starter...
  8. B

    For Sale 2000-2003 Husaberg engine

    Looking water pump cover for my FC470e! part from all engines from 2000 to 2003.
  9. canaberg

    2004 FE650 With Bent Engine

    Hey All! I want to run through a brief history of an FE650 I need to move to someone else to find out what the UHE populace thinks I should do as a next step. I have an '04 FE650 that was purchased from the Corner Grass guys here in Alberta, Canada after they won the Endurance Ice Racing...
  10. U

    For Sale Engine Wanted

    600cc Husaberg engine for a 1998 FE im in San Diego, CA
  11. D

    Fs650 engine maintenance

    2004? (I think)Typically how many hours/Kms are these motors good for before a strip down. Currently only being used on short runs until I iron out all the issues. And what would be considered routing maintenance in terms of pats replacement,are valves expendable,what’s hours can a piston take...
  12. A

    96 600cc engine fit a 95 501cc chassis ?

    Hey guys, I was curious what the cross over years are on the older models. I am wanting to put a 1996 600cc engine on my 1995 FE501 chassis. Should I expect issues or is it pretty much a direct mount from one to the other ?
  13. R

    Need Engine Sound Advice - See Video

    Bike is new to me and no other Bergs around to listen to. How does it sound? I adjusted the valves last week- should have took audio beforehand. Now I’m not confident in my work. Bike has 50hrs. Work done at 70F. Exhaust valves were in spec on the loose side. One intake was tight, one loose. I...
  14. W

    2007 FE550E Engine Work

    My ignition rotor (flywheel) doesn't want to move. I didn't have the puller, so I bought the Motion Pro, it has the nose cup for the crank tip. I can't use a torch, the magnets are glued in place. I haven't tried an impact yet. I put some thin lubricant on the fit and loaded the puller tight...
  15. O

    JBS 700 engine

    Hi, got a 700 engine on my bench that was shipped out to OZ from UK, was started and blew smoke and oil everywhere within 30 secs then shut down, first thing i noticed was wrong head gasket 103.7 mm bore and 100mm head gasket fitted ??? not good!!. Will be looking for a 103.7 head gasket and...
  16. P

    Engine part alignment and adjustments on FE 400 1998

    I've been trying to search everywhere on how to align and adjust everything in this engine as i've taken it apart ELEVEN YEARS ago and now i don't know how to align it as said i've been looking everywhere for manuals and and kind of help for this model but can't find any so please is there...
  17. M

    Engine rattle..

    I recently aquired a Husaberg fe450e 2006, which had stood still for a few years. Upon start up i heard some rattle, so i did some research and came to the conclusion that it was the CCT. I took it out and checked it, didnt seem to be faulty in any way, so i reset it and put it back in. Then...
  18. E

    570 engine

    Hi, Anyone here selling a 570 engine? Or crank case?
  19. Vandor501

    Engine repaint/ refurbishing

    Hey guys, Noticed my engine covers and some bolts just look really sad from corrosion so while I set my valve clearances last Sunday i figured I'd try some new color combos/polishing up some covers. Here's a pic of before and after with valvecovers. I'm probably going to blast and...
  20. H

    What year engine

    Hi all:) Could anyone identify this engine for me please :o The chassis is a 95, but I know the engine blew up and was replaced by the dealer... No e-start possible on the engine, but filter oil cartridge...
Back
Top