Pretty good chance this has been brought up already.. The search engine failed to get me anywhere.
I have the Forks off the bike, And the Tubes unscrewed from the Cap... The Nut that's held (inside the springs) is exposed. I understand that I need some kind of Pin wrench.
I recall some one using an Allen wrench Jared behind a screwdriver to get the Cap to budge... Damned if it worked for me.
So I butcher'd an old ring spanner and welded some prongs onto that............ But The Pr**k of a tool just slips out of the holes, scratching my Cap...Not impressed, Is it showing? lol.
If I can get a good grip on the Cap, and the bottom 21mm nut (where did I read it as a 20mm??) should, I have to much issues? Is this normally a tight fit?
Dan
I have the Forks off the bike, And the Tubes unscrewed from the Cap... The Nut that's held (inside the springs) is exposed. I understand that I need some kind of Pin wrench.
I recall some one using an Allen wrench Jared behind a screwdriver to get the Cap to budge... Damned if it worked for me.
So I butcher'd an old ring spanner and welded some prongs onto that............ But The Pr**k of a tool just slips out of the holes, scratching my Cap...Not impressed, Is it showing? lol.
If I can get a good grip on the Cap, and the bottom 21mm nut (where did I read it as a 20mm??) should, I have to much issues? Is this normally a tight fit?
Dan
