throttle

Hi guys I am back, I have another question regarding my 2004 fe450. Can someone shed some light on what my problem might be. So when I go from idle ( stand still or descending a hill under load etc ) and open the throttle quickly it wants to and sometimes does stall. If I tweak the throttle...

Hi guys, I bought a set of ODI half waffle Lock-on-grips and the adapters for the throttle tube don't work with the OEM Domino throttle on my 2003 FE400. There is one adapter that is very close but it's a few mm to large. Not sure what throttle that might have come from. The packaging for...

So after solving my cooling problem now a new thing came up. A month ago when I was reving my bike for fun or just to show off it didnt have any problem(had no backfires), running normally, reving up normally. But like a week ago when I do the same, even if while moving, pulled clutch and full...

Fine at tick over or when letting off Kind of hard to find culprit as I can’t get off and run along side it to find where the noise is coming from I can rev out of gear and the noise is not present either. Don’t know whether they’re linked but, it is hard to find neutral, like unable to find...

So is it the Motion Pro 05-0286 that is a few inches longer than the stock cables on my 08' fe450 ? I did a bar riser of 1inch & dont like how tight it is nor do I wish to run them behind the tripples. Brand Motion Pro Model 05-0286 Item Weight 11.2 ounces Product Dimensions 11.5 x 0.3 x 0.3...

Hi folks, I have an 02 fx 650 converted to fs and running with a racing FCR 41 (not the mx, no choke) and standard exhaust. Fuelling looks good on the dyno and getting 55hp at the wheel so happy with that. The issue is what feels like a missfire /luching/surging at 1/8th throttle. The dyno does...

Hi guys, I’ve got a throttle body for sale that will fit all 70° models, from 2009-2012, 390/450/570. It's in very nice condition, engine dropped a valve with just 84 hours. Comes exactly as pictured. $220 + shipping, I can ship world wide at low cost. I could ship it directly to...

After leaving the bike for a month (traveling) the throttle is extremely difficult to twist. Where do I start to clean/loosen it up? FE570

Well guys, I THINK I finally have the ignition and wiring sorted and am about ready to get the old beast going. But... I need a throttle cable (or a set of them?). But, without ordering from GB, does anyone know where I can get one?. The only other remaining question I am battling with is...

1998 FE400 with a Mikuni flat slide carb. What throttle cable do I buy?

hi all, troubleshooting a problem i've had for a while on my 2011 570FE. if the bike is cold and i chop the throttle while the bike isn't engaged (neutral or clutch in) it's almost like i can hear the intake burp a little and the bike cuts out. it's not always the easiest thing to...

Hi again! Fitted my carb (FCR39) back on the bike (02 FE650) after having an overflow problem and now the throttle sticks for about a second after i shut off? Is this just down to the cables or something to do with the carb itself? Thanks, Harry.

Anyone know where to get these?

I have a 2011 fe570 with 108 hrs on it. issues started a week ago with surging when holding a steady throttle, progressivly got worse to the point where it would idle but on throttle of 1/2 or more it would die with whats sounds like a bit of a back fire. its now to the point where it will idle...

loving my Berg, don't get out as much as I should though.. went to the last Watagans Trail Bike rally recently and for the first time noticed the play in the throttle.:confused: Its not much but the more I thought about it whilst riding the more it bothered me :mad::mad: I checked the...

Hiya, Just went for a short spin on my 570 with a fresh, topped-up battery in. I ... it ran quite a bit stronger than I remembered?! As in instead of it being relatively easy to have the front wheel slip to the sky, it felt HUNGRY and the wheel WANTED up and there were JOLTS to the chassis...

I have a 2010 FX450, used primarily for Supermoto. I have been chasing an intermittent dying issue for a while now...and now I'm asking for help. Typical scenario...bike is warm/hot, idles fine and will run fine if I short shift, keeping revs below say, half throttle. When given full throttle...

On acceleration, hard or soft, will randomly die and will restart only if engine stops reving. Meaning if bike is still rolling i pull clutch to allow engine to stop reving and release clutch slowly and engine will start again and run normally. Also will restart normally on kick or e-start...

Does anyone know where I can get a 96 fe 350 throttle cable?

hello everyone, this is one of my first posts here. i have a 2009 fe450 that needs a little bit of throttle to start when the engine is warm (still might take two or three goes). However when it is cold, the berg fires up right away at the touch of a button... i have read somewhere that this...