switch

When installing a headlight on a 09 450 I noticed that one of the wires heading into the map switch connector had been sheared off at the base of the connector itself by a zip ty. The wire that is still remaining is not long enough to do anything with. I am curious if anyone may know where to...

Just curious if anyone has installed the map switch yet. What's required to get it to work? Is there a noticeable difference in the maps? Can you install the switch, set your bike to performance, then remove the switch? Dalton

Does anyone know if the Husaberg will accept a mapping switch like the KTM?

Hi All The temp switch that came with my cooling fan is rated at 85 deg c cut in and 80 deg c cut out, basically the fan runs most of the time, I have read that a lot of people install a separate switch, I do not want to do this, so was wondering if any of you have sourced a higher rated temp...

I haven't tried this switch yet to see what it does as I've left it in the low position. Does it actually do something that's noticable when it is switch between the two settings particularly for a supermoto?

Hi, I am considering a fork switch on my -92 350 because it is getting quite hard to find parts and configuration info for the older forks, and a newer fork is possibly better. I have the option of buying a fork from a 1999 501 but are not sure how it will fit on my bike, and have some...

My key switch is shot and I don't feel the need for one. Can i simply rewire to a toggle switch? It looks to me like I need to connect the brown, orange and red/white to one pole and the red/black to the other pole. Comments?

Hi everyone, The choke lever on my bike is impossible to reach (2000 FC600). The lever is hidden up near the top of the carb between the frame rail and the tank and you need very skinny fingers to operate it. It's been starting kinda OK without the choke, but has become VERY difficult on the...

What would be the best spot to put a Selco temp switch that closes at 190F and opens at 160F, in a DIY fan configuration? I was thinking about putting one by the inlet (where the coolant arrives from the pump). But at that position, would the temperature rarely go under 160F? I could also...

Had a 450 at home this weekend for a suspension tune. Done Friday with the usual success. Trouble was it wouldn't go at all on Saturday after running fine on Friday. Would tempt occasionally with some noise but.... After an hour or so of trouble shooting, first thinking it was flooded, then...

Hiya I revently took my 2001 fe650e into the shop to have the brakelever replaced, when i got the bike back, they removed the manuak decompression switch (i think that what it is)the little lever on top of the clutch lever........so,well anywayz......the removed the cable and the little lever...

First and second gear will go in easily, but switching on third is hard, but after useing some force and leting down gas it goes in. After reaching on third, upper ones go in easily again, but when i switch back on second, again reaching third is hard. If it helps, one time I almost didnt got...

The stock thumb switch on my 2002 FE501e is shorting to ground whenever the lights are turned on, killing the low beam, running light and brake light. The problem is in the switch itself which is hard sealed. The factory replacement for the switch is a complete wiring loom for $180 with the...

Husa-brothers, I want to remove my keyed ignition swithch on my 03 fe400e. I've disassembled everything, read through my wiring diagrams and searched here. there are 4 wires going to the switch. Which combination to I connect them in with the key switch removed? I want to keep my full...

Hi all, First post here. New to the berg, a recently purchased fully dualsported 2005 FE550e. Can't wait to get riding! Although, really uncomfortable not having a key. So I am planning on wiring a key switch and a relay to disable starting and all electrics on the bike. See wiring...

2000 501 FC- I just picked it up last night and in low it runs good, but switching to high it idles rough, stalls in first, switching to low it runs up fine and switching to Hi on the fly it starts to backfire and choke up. The original SEM CDI was in a box the previous owner gave me so I do...

i may have asked this before but i've done a search and nothing came up. my brakes operate only at the bars due to the rekluse set-up. i have nissin on the right and the converted clutch on the left. what is the daintiest cute 'lil switch i can fit that will give me a brake light...

Is there a keyed ignition switch for the 06 fe650e? I am slowly doing a dual sport kit, switches, lights, horn, turn signals ect....all from husaberg but cant seem to find a ignition switch. KTM has one, does husaberg rely on the steering lock for theft protection only?

I have one of those remote 3 button speedo switches for an '03 that I'm about to hook up. I have no info on what the buttons do. Anybody know or have info on their function? There's nothing in the manual or the schematics. Thanks for the help.

:?: The light switch on my '02 FE501e appears to have lost all of it's guts. The plastic toggle will spin completely around in there without turning on my lights. I haven't dug into the thing yet but are there any replacement parts available (ie... springs, contacts, etc) that I can get to...