shaft

Hi guys, i'm just rebuilding my 03 550 and am unsure about the axial positioning of the balancer drive shaft. it seems to go as far in as you press if until the gear fouls the case, where is it supposed to run? this would surely affect the cam sprocket alignment too. Any help much appreciated as...

hi all folks, while rebuilding my engine i noticed that the exhaust rocker shaft had a radial play more than 1mm. i removed it and saw that it was very worn. the place that it rests(dont know the right word) from the one side is the endplug, right? its hole turned into oval and so did the...

Hi guys, Just had the clutch side cover off my bike(full cover not inspection plate..04 650 sm) to check the installed gap on my rekluse....once done I put it back together and the kickstart shaft is solid.... I loosened the side case again and the shaft will move. I removed the case and...

:( Broke my kick start shaft and bent my kicks tart, my dealer has been good but this is just another one of those things that make the yam i sold feel like the best bike i had ever had, i am just hoping that 05 brings me some trouble free Husaberg riding, when it starts and runs its the best...

Counter balance shaft gear keeps coming loose ? I've replaced the woodruff key as the old one broke up. There seems to be no wear on the shaft or gear and I trimed the new key down when fitting it but the noise has come back again ? Any advice Guy's. :oops:

thanks for the answers, will tray with red loctite and very clean surfaces franco