rocker

Hi Folks I am in need of a set of 27mm exhaust valves and 30 mm intake valves I also need an exhaust rocker for the same bike. 1995 350. Motor ser# says 1992 as manufacture date which has 10 mm rocker shafts. I have machined these out to 12 mm so new rocker will work. I would even be...

Gentlemen! New to this forum. New to Husaberg. Pretty good wrench. Bought myself a -02 501 FE that had little over 100hrs. The bike was very well maintained and had been driven responsibly by an oldtimer. The -03 rockers and steel sprocket were already fitted and the rollers were at apx...

Okay I have looked but can't find the thread that was being discussed recently about the best sealant for the rocker cover can anyone point me there? also, does anyone know if there is a "rebuild" kit for the dellorto seals and gaskets and such.

I reported earlier that what I expected to be failed rocker arm rollers making an odd top-end noise turned out to be a shredded water pump impeller. I've finally had a chance to look a little more closely and what I'm seeing is perplexing. The remains of the impeller, new about 100hours...

Finally got a chance to pull the rocker cover last night to inspect the failure. What I found was a bit of a surprise. The rockers are in excellent condition with no detectable wear. The noise that I assumed was one or more failed rollers turns out to be a water pump impeller that I took out...

Hello Everyone, I am an infrequent visitor to the site so I'm not up to speed with the latest. At the end of a 100mi ride saturday, I heard some unusual noise from the top end. I haven't gotten into it yet but suspect I've lost the rocker arm needle bearings again. I changed them about 120...

hi all folks, while rebuilding my engine i noticed that the exhaust rocker shaft had a radial play more than 1mm. i removed it and saw that it was very worn. the place that it rests(dont know the right word) from the one side is the endplug, right? its hole turned into oval and so did the...

one of my rocker end caps appears to be leaking oil. from the drawing i'm guessing the o-ring is the culprit...maybe it's cut. can these end caps be removed without removing the rocker assembly? doug

Hello, I am running a 2002 650 SM. It has a 53 cam and the 2003 rockers. I am getting a bit fed up with replacing the rocker bearings (rockers assembly) and was wondering whether fitting the 08 cam would allow me to increase the interval ? Looking at Dale's graph...

Hi all have just had the frustration of finding that the thread in the head for the rocker cover bolt which goes through the exhaust rocker pin is stripped. have just had new rocker bearings put in by dealer after i removed the rocker cover myself. when putting back on had difficulty as...

:( The weld repair went well, but valve cover did not remain flat enough to seal against the top of the head. Still leaks. SO, I was wondering if any of you Berg mechanics have a good used valve cover available for sale to fit a 2002 400e. ? . All I need is the cover; my rocker shafts, arms, etc...

I checked my rocker bearings (63 hours on engine), they are snug as a bug with no lateral movement. But I did notice alot of lateral movement in the intake rocker arm. I am able to move the intake rocker arm .060 (1/16") side to side at the valve adjustment screw. The exhaust rocker arm has no...