issues

So a few weeks ago I was headed out to the trails when my '10 FE 570 started acting up. I tried to give a sharp throttle input at about 60mph and there was no response. The bike bogged down on me. Took it easy to the trailhead and that's where problems really started. In second/third, the...

My 12 570 was running perfectly when at the start of one ride it kept stalling after blipping the throttle. It seemed okay most of the ride but at the end, when I went to pop the wheel up for a big log off idle it bogged down and died. I've had the injector and filter ultrasonically cleaned and...

so, i bought a used fx 450, 2010 model year. It had the stock cct in it. I ordered a djh type, decided I was going to check the valve clearance while installing it. So, i drained the coolant, which was not your typical green mix, pulled the LT rad and valve cover, had to get a bit thicker exh...

Just got this 03 FS650e a couple weeks ago and its been running great. No issues... until I cleaned the air filter and reoiled it. Now when the engine is hot, it has a flat spot just off idle. Killed it a few times leaving a light. Sux when you have to kick it... Anyway, everywhere else...

wondering if you lovely people can help me my bike is a 2002 fs650e supermoto since owning it i have had a couple of issues ... nothin major as a carb strip and clean didnt half fix. see the bike has been stodd for a couple of years before i bought it and everything inside was mingin, there...

Gidday all me old buddies on UHE - its been a fairly long absence from the site, but pleased to report that the happy little family of 2 Bergs (and me) have been running relatively smoothly. I was just dropping back to look for a fix for a sticky / jammed gear shift - and of course found some...

Hello folks. Former KTM owner, now FE450 2008 owner :oops: I loved the spanner time on the KTM but the berg is slowly destroying my love of bikes. Please someone help before I set light to it :evil: As usual the issue started with water pump seal leaking oil, I got it done easy all back...

Loving my new 2012 FE570, I did a pile of googling for known issues and mods required for a new berg and thought i'd just list everything I found here to save a bit of legwork for anyone thinking of buying one of these awesome bikes. Hope no one minds me rehashing stuff they have already posted...

I just picked up a low mileage 2011 570 fe. The bike had never had the factory headlight installed, just the number plate. I fitted and plugged everything in but no light. No high beam, no low beam, nothing. There is no power at the connector but the fuses under the seat are all good...

I couldn't find a similar issues in the previous posts...so: Cold starting no problem, but after about 10 min of riding I have to put the bike in neutral and pull the hot start on the carb, crank it for 4 seconds and then give a blip on the throttle and it will start up. Would this be exhaust...

right, few issues with the recently purchased 09 450...... yesterday was out doing some fairly technical moorland riding, quite a bit of rev'ing, clutching, carrying, pulling, pushing and plenty of water, this was fine for about a hr and then the bike went on its side in about 4-6 inches of...

2010 FE390 to date no injector issues and hoping to keep it that way. I am considering the Splitstream tank filter; the ad reads "Most fuel injector nozzles have 50 or 60 micron holes, so Splitstream used a very fine 25 micron mesh for their fuel filter bags, helping eliminate clogged fuel...

Hi guys I'm new to the world of Husabergs. I have a chance to buy a lightly used 03 400fe, really good shape, it runs and goes down the trail fine onlyon the 2nd rear tire, original owner. The power seemed very similar to my 01KTM 400RFS. I can see no issues, but I would like to hear the good...

KTM is really getting it's ass kicked on the other websites. Tons of bad fuel pumps and injector issues.... http://beta.thumpertalk.com/topic/89796 ... ssue-2012/

Something is up with my front wheel. Since cleaning up the inside of my motor (dvsk, bigger valves, match porting, a slight bump in compression, and sorting out the jetting with a Barret muffler) now if I use a bit of throttle in the lower 4 gears the front wheel wont stay on the ground! (to...

i have an issue with my '02 fe650e clutch line. the connection at the master cylinder is 'wet' and even when i retighten the fitting it still weeps. when i take it apart the fitting it looks like the end where the fitting is supposed to have a slight flare is totally flattened. does anyone...

All, There are some great threads going here about trouble shooting, identifying, and repairing of the fuel pump's on the post 09 bikes. I have made those threads sticky's to keep them at the top of the "fuel" forum page. When possible, please make contributions to the existing threads...

Has anyone had this issue..... When i blip the throttle the revs return to around 2300rpm then slowly drops to an idle maybe 3sec . Had the the throttle grip to bits and adjusted the cables and all that seems to be fine. When i snap the throttle with the engine off the butterfly is closing as it...

Polaris and KTM have collectively recalled more than 2,000 motorcycles because of handlebar clamp issues. http://www.powersportsbusiness.com/outp ... id=2763109

Went for a good ride for about an hour, then the bike was running hot and the fan was on and off for about 15 mins. I high sided ontop of a boulder where the bike hung up but kept running. I picked it off the rock and kept riding for another few minutes and then I stalled it. To my surprise...