issues

Got an 02 fe400 recently. All works EXCEPT I get no tail light when headlight switch is on low beam. Switch on high beam and it works fine. I tested the switch and everything seems to work properly. Any ideas on where the circuit may have failed?

Hey all. Just doing my valves on the FE570. I took the cam out but the rockers wouldn’t fall back far enough to access the shims. The manual says “raise the rockers” and I remember distinctly the last time I adjusted valves I could roll them back all the way. I think. This time the intake rocker...

Hello everyone. Hope some one can shed some light on the following . I have a 2003 Fe501, It will start ok kick starting. But im getting old ,so after about the fourth get off per day I would like to be able to start on the button, So the mods I've made so far are R6 Starter motor. New...

I'm having electrical issue my 08 Fe 550 have intermittent headlights indicators and speedo seems like my headlight controls my brake light and tail light brake light comes on on low beam and the tail light comes on on high beam but not both together and nothing works when you hit the brake...

Hey fellow enthusiasts! I just purchased a 2010 FE 570 with only 80 hours. My name is Tony and I'm from Spokane Washington. If anyone is in my area and wants to ride let me know! I have a few issues and was wondering if anybody could chime in. Here's my short list: First 5 minute ride she...

I recently bought a 2011 FE 570 EU-model and am trying to find out why it's CO value is quite high. I don't know if it still has the original mapping on it. I tried to check the lambda sensor but I'm getting a strange result. I did bridge two pins in the diagnostic plug before the battery so...

Hey still pretty new to the world of dirt bikes and recently my 05 fe450 started having issues starting up it didn't have before. It starts up fine but if I try and give it any throttle before engine is warm it dies. Haven't been able to figure out the reason would love if anyone has some info...

Is the sprag clutch known for failure on these bikes? If so are they available? If one can be found, are they hard to replace? Thanks for any info.

Hi all, have a issue with my fe390 Recently, when starting the bike the starter wil spin but not turn the motor, but if I put into gear and move the rear wheel it will seem to engage and then crank the motor I have replaced the starter, tensioned the torque limiter and checked all the teeth on...

I have a 2007 husaberg FE 450 which has been having trouble starting recently. It only has about 300 miles, carbs have been cleaned, and brand new battery. It has trouble starting. When it does start, it often dies especially when throttle or clutch are applied. Each time I start the bike I put...

Hey, Has anyone else had any issues with their rear brake on a FE450, 2013 Model? My rear brake needs to be pressed about half way down before any braking power kicks in. I've installed a new master cylinder, do you think it just needs to be bled again with a bit more fluid? Or could...

Taffy, whats up w/ bump & spin free on the elec. start on my 08'450 ? I looked at your site for maybe a spring/kit kinda thing but didnt find anything. The decompression is not hooked up on my bike if that makes any difference. It kicks & fires right quick. Thanks--Proflow

Good Day all, So over christmas i installed a new starter Motor, Bendix, transfer gear, starter relay and battery. Tried starting it cold engine turned over slowly but would not fire. Tried it when warm and the starter relay went and its never even started the bike! I have noticed 1 of the...

Heya Bergers. The short version: I have no way to measure my liner in order to spec a replacement piston. The long version: Some bearing noise and steel shavings on my drain plug inspired me to finally tear down my 2008 FE550 after 210 hours. I found my main bearings were toast (as...

Hi, My recently purchased 2008 FE550 has a bit of weirdness with the transmission. I can find neutral fine with the engine off. When I start, then put in gear, no problems. But while engine running, 1) can't shift back into neutral. And 2) when running, in gear and clutch in, it...

Hi just new my name is Les from Newcastle Australia and I was wonderingif ang one could tell why lately my 2013 fe250 is getting hard to start. it used fire up easy even without the cold start button cheers

Having issues with TPS or so it seams. FI light flashes 6 short and 2009 570fe bogs intermittently, sometimes completely stalls. problem comes and goes, have replaced my TPS and have set with multi-meter. runs fantastic for a while then problem always comes back. Any suggestions?

Hello second time posting here you've been really helpful before so here goes.... Bike: 2014 husaberg te300 Issue: rear brake light stays on when lights are on So yeah the rear brake light is staying on when I put my lights on, when I turn the lights off the brake light works fine. It's a...

I'm trying to get into the engine, to check the cylinder head. I have run into trouble getting the timing chain off. whats the best method? I'm considering splitting the chain but any other suggestions are good.

G'day lads, I'm hoping some of you might be able to help me out. I've Had a lingering issue with what seems to be fueling or ignition with my bike. Over the last 18 months I've replaced plugs, fitted a new fuel pump, cleaned the Injector and replaced filters, nothing has worked. My bike...