issue

Hello all :o My bike fires fine on the kick but Will not start on the button at all??? I have replaced the battery with a "beefy" Lipo type with around tree times the cranking Amps and upgraded the wiring since the battery now sits under the Seat... It turns over but Will not run at...

Hello to all. As a lurker for a while, thanks for all the info that persuaded me to buy a Berg. 2010 fe570 with 30 hrs, 900 miles. Bought it from a friend who used it to ride around town. He never got after it and it has had no issues. I've had it three weeks and the other day I was out running...

Hello , I am new to forum and think its best place to start solving my issue with recently 3 week ago bought Husaberg. The problem is with the idle. When I bought it started well with the choke on and was running ok with choke on. Then when I went for a ride I could barely ride 1km when ...

I've had some issues with my 390 quitting on me. So far I have replaced the fuel pump, replaced the injector, all new fuel filters, checked the valves, new plug and plug cap, and set the tps. What it does is it will start right up and then while idling for a while (seems like once it warms up)...

Hi folks, I have an 02 fx 650 converted to fs and running with a racing FCR 41 (not the mx, no choke) and standard exhaust. Fuelling looks good on the dyno and getting 55hp at the wheel so happy with that. The issue is what feels like a missfire /luching/surging at 1/8th throttle. The dyno does...

Hi, When my bike gets hot usually after 40 minutes of riding or less if it's very slow hot technical stuff the clutch lever resistance begins to disappear. Eventually if feels like the hydraulic line has been cut and there is bugger all resistance at the lever so the clutch can't be...

Hi all, I have a issue with my charging system where I'm getting a low voltage on the DC circuit at higher rpm. I've replaced the original head, tail and indicators with led types. Indicators and head light were on the DC circuit and tail on the AC circuit. I'm pretty sure the issue was there...

I seem to have an electrical issue causing the engine to shut down after starting. The battery is fully charged - checked, start the engine - runs for approx. 3 seconds and then shuts down like the kill switch is activated. does this until the battery runs flat. I have just finished installing...

I recently bought a used berg. It's a 2002 fs650 supermoto. All seemed fine, rode for 60-70 miles and all of a sudden it just died! No cough or splutter. Just cut out. I clutched in and rolled off the road. I couldn't restart the bike, the starter motor still worked but wouldn't start it...

I'm now on the last legs of getting this Berg up & road ready (02 FE650). I've had the lump checked over by DCR and the carb set up etc. (By post as we're down south) We fitted the carb today, fired her up, she idles lovely, but for some reason the revs are sticking for around 5 secs after...

2003 fs650e, I picked this up of a friend (ex friend now) it had not been started in nearly 3 years. Put fresh fuel and oil in, no start. Stript carby and clean, new plug, no start. Then thought I would do the valves, spent hrs on the www, looked easy enough, intake slightly out, exhaust way...

My 09 fe450 runs fine from cold but when when it gets hot (Boiling rads hot) it starts to stall in low revs, like the kill switch has been hit for 1-2 seconds starts to die in low revs. Today when out and the bike was warmish I stopped and it would not restart for about 30 seconds just had...

Ok 1997 HusaberG 400 So my bike was running great , then suddenly it just stopped, go it to run another 1/2 mile then died again I checked for spark and couldn't see any It was raining a lot !!! I phoned a friend to pick me up and got towed back home after waiting half a hour in the...

Hi all you freaks, few weeks ago I bought HSB FE 400 (2003). After many machines I've owned, finally, I found the right one which absolutely fits me and I want to keep FE for a long time :D. Unfortunately I am facing a serious issue with cold start (two weeks before my planned trip to...

Hi guys,new to the forum and recently got on a 2004 fe450.recently replaced the clutch cover gasket as it was leaking oil and after the greif of getting the kick start shaft and mechanism to stay put i finally got the cover on and all sealed up.kick start works fine and have taken it gor a day...

Hello, I have 2011 Husaberg FE570, and I am having an issue with backfiring when you slowly increase the throttle. If you open the throttle all the way is seems fine, but if if slowly increase the throttle it backfires. Also when I am riding the bike it seem to loose any high end power when...

Hi guys I m new to the enduro world and bought a second hand bike that was not look after at all. I have been on 3 rides with no issue and last week I replaced my air filter load up the bike in my car the next morning (started no issue) drove to our driving spot and nothing, bike turns but does...

Hello Im wondering if there are any guides on how to check on the crank bolt? Ive heard that the 2008 Bergs have a problem where the crank bolt will loosen and **** up your bike, and I wanna check on mine. And correct me if im wrong, but there are two bolts, the upper one should be...

I did some maintenance before taking my bike up north for some riding. I just changed the oil/filter and did a valve check not too long ago. I also had the bike checked at a local Husqvarna dealer because on a previous ride I heard a very concerning noise "Which ended the trip". I thought...

Hello Guys once again I have to ask you for help and advice regarding my Husaberg 501 '97. Engine is now after a nearly coplete rebuilt but it did not start at all. Seems to be an issue either with parts or set up. It kicks back while using kickstarter and does not start. The obvious...