arm

One of my rocker arms has a radial play of about 1mm... The one on the exhaust side. When I push it back and forth, I hear a little "tick!" sound. I can see it move and I would think it's about 1mm. I tried to adjust with the #3 allen screw in the front but nothing. Or sometimes I manage...

as i've said before through other posts the SAPP is undersized on the husey. this sends the dowels over at an angle and means that the needle rollers only ever touch in a small area which wears them out in no time. don't believe me? undo the nut and loosen, then grab the rear wheel...

Those who were at Moab this year must remember my stepson Kenny, who was riding a WR 250F. Back then he was just recovering from a wrist fracture following a beginner's mistake on the trail which is why he was holding up a bit. The ER MD did a very bad job when he put the bone back...

Gentlemen! New to this forum. New to Husaberg. Pretty good wrench. Bought myself a -02 501 FE that had little over 100hrs. The bike was very well maintained and had been driven responsibly by an oldtimer. The -03 rockers and steel sprocket were already fitted and the rollers were at apx...

This is from my Berg which was purchased 14 months ago brand new. I have meticulously changed the oil and airfilter all the time as well as regular valve clearance checks performed by Dealer. No warnings and this is what has happened. I have done 3000kms on it so far. I am chasing up Husaberg...

I reported earlier that what I expected to be failed rocker arm rollers making an odd top-end noise turned out to be a shredded water pump impeller. I've finally had a chance to look a little more closely and what I'm seeing is perplexing. The remains of the impeller, new about 100hours...

Hello Everyone, I am an infrequent visitor to the site so I'm not up to speed with the latest. At the end of a 100mi ride saturday, I heard some unusual noise from the top end. I haven't gotten into it yet but suspect I've lost the rocker arm needle bearings again. I changed them about 120...

ok motor is just about out but i cant get the damn swing arm bolt out in the manual it says to pull it out of the right side...does it have to come out the ride side :?: I have belted it and i have tried taking the bolt off on the right side and tightening the the left bolt to see if i could...

I checked my rocker bearings (63 hours on engine), they are snug as a bug with no lateral movement. But I did notice alot of lateral movement in the intake rocker arm. I am able to move the intake rocker arm .060 (1/16") side to side at the valve adjustment screw. The exhaust rocker arm has no...