air

hello, I have ordered also a x2 cam for my husaberg 650 2004, My question is do the carb need to reset. I mean much leaner or richer?? the owners or manufact.feel free to respond. greetings Mathieu

just wondering what the best protection is across that radiator? not worried about the beauty of it-just protection and letting air get through! was told years ago that the exit was as important as the entry and that the entry should be smaller not larger than the CSA of the rad. :shock...

If this has been mentioned before... excuse me... but A perfect cover to stick over the air filter whilst power washing her down is cheap and easily available over here in the UK from Screwfix Direct. Over shoe covers No. 29124 Will last you forever... certainly longer than your Berg ...

Hi, Any ideas about which material to use as air filter protection? I will replace the material sticked to the frame and fitted under the seat.

Is it OK to run it un-oiled? I think this is the main source of oil in my carb boot :oops: Rowley

Hi all, In a quest for more power i am considering a revised air intake setup on my FC600 / 41mm FCR setup. Since the ideal airflow characteristic for a carb intake is laminar flow with minimal resistance, the 90deg inlet rubber on the back of the carb to me seems like a major compromise...

I have always noticed a bit of water collecting in the bottom of the carb intake boot after washing. Even after a ride I can see the residue of dirty water that has left a few streaks inside the carb boot. I have found that the water gets in at the top of the rubber along the flat side of...