This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

For Sale WANTED: 470 parts

rumpoldstilskin

rumpoldstilskin

Joined Jan 2018
3 Posts | 0+
Burscough
Hi all, new to the forum, yet to post much due to still being unable to remove the swing arm shaft- seized in there well good.

Anywho- after a road registered 470 frame with V5 preferably, or registration plate so i can HPI check it.
Looking for;

Head gasket/gasket set
Kick start lever
Clutch master cylinder including decompression lever
Side plastics for the tank (have two circular holes in them i believe)
Water pump bearing
Spark plug tool
Chain and sprocket set
Front and rear fender plastics
Bolt kit?


Any help/pointers greatly appreciated, i’m in west lancashire, UK. Cheers, Will
 
paolo6 said:
Have you try DCR? is not far from you
Click to expand...



I have yeah, lovely guy, bit too pricey at the moment for me though (pesky wedding coming up), I know he’s the top go to guy too.
Also not sure if my car would survive that country lane again- previous egit owner lowered it ffs, got stuck on that first speed bump [emoji24]
 
Ahaha yeah that first speed bump is a pain. ...apart from eBay or Facebook I don't know where else you could find some ''used parts cheap'' ...I could have some coming up soon ( not sure when) ...but yeah ....all the best it will end been either weeding or bike :p

Bring a ramp for the car next time :)
 
shrouds

rumpoldstilskin said:
Hi all, new to the forum, yet to post much due to still being unable to remove the swing arm shaft- seized in there well good.

Anywho- after a road registered 470 frame with V5 preferably, or registration plate so i can HPI check it.
Looking for;

Head gasket/gasket set
Kick start lever
Clutch master cylinder including decompression lever
Side plastics for the tank (have two circular holes in them i believe)
Water pump bearing
Spark plug tool
Chain and sprocket set
Front and rear fender plastics
Bolt kit?


Any help/pointers greatly appreciated, i’m in west lancashire, UK. Cheers, Will
Click to expand...
i have blue a black shroud sets 2 holes.
 
  • Like
Reactions: 1 person
About your stuck swingarm bolt, I have heated the cases where the bolt goes through. Then worked out the axle with a punch and hammer. I have had great success doing it that way.
 

Similar threads

D
For Sale Parting out my 2001 FE650e
Replies
6
Views
563
Danger666
D
H
For Sale 1998 fe400 husaberg part out
Replies
3
Views
2K
Trentw19
T
M
For Sale 04 FS450e factory sumo part out Washington, USA
Replies
2
Views
2K
cambo
C
I
For Sale 2005 FE550e and FS650e parting out
Replies
76
Views
22K
anthonys4691
A
P
Good deal?
Replies
17
Views
3K
BendBerg
B

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions