Hello fellow Husabergers. I just got done tearing my bike down to replace the head gasket. The head was warped so I used dykem dye and sanded ( or lapped) the head with a piece of granite and 400 grit. Just put it back together, fired it up and there is goo coming out of the right hand side of the intake at the pipe. Sounds like I did something wrong. Also is it okay to use a cam chain master link with a clip? I’m ready for the abuse. Thanks
Possible Head Gasket Issues
- Thread starter Mojoberg
- Start date
Help Support Husaberg:
The goo is coming out of the right pipe where it connects to the head. Never seen that before. To be honest, I tightened down the head with a new head gasket and ended up having to take the head off again and re install and tighten again with the same gasket. I was hoping that might be the case and nothing more. Hoping I just need a new gasket again.
- Joined
- Nov 20, 2001
- Messages
- 17,032
- Location
- Ely, England
the rocker cover tends to ooze oil out the front and down over the exhaust port and HG area, the exhaust port often gets the blame. look from the silicon beed down and if it is shiny (with oil) up there it is the rocker cover not the exhaust port.
we did have trouble with 100mm head gaskets. mine were plain and the factory ones have a blue beed of gel around the perimeter.
Taffy
we did have trouble with 100mm head gaskets. mine were plain and the factory ones have a blue beed of gel around the perimeter.
Taffy
just a couple of days away of testing her out again with a new head gasket
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
