This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Particles in olie + chain tensioner broken???

T

ThomasB

Joined Feb 2024
7 Posts | 0+
Denmark
I have dismantled my engine a couple of times now, changed the main bearings, and corrected a problem regarding the sprocket for Kickstarter which the former owner had mounted in the wrong way, so the shaft and gear were bad, I checked and cleaned the engine inside.

It starts an sounds perfect and drives great now :)

I ran it for an hour after the rebuild, but there is what I think is a lot of debris in the Olie mesh filter and on the magnetic plug?
Is that normal to a Husaberg?

The cam chain tensioner was also broken after my ride?
I don't now why i broke?
 

Attachments

  • cam tensioner.jpg
    cam tensioner.jpg
    545.7 KB
  • olie.jpg
    olie.jpg
    2.7 MB
Pull the tensioner out and have a look? like you say, it shouldn't have broken?

It's a job to know where the steel is from but I suspect the main bearings. it is though, only a guess!

regards

Taffy
 
ThomasB said:
I have dismantled my engine a couple of times now, changed the main bearings, and corrected a problem regarding the sprocket for Kickstarter which the former owner had mounted in the wrong way, so the shaft and gear were bad, I checked and cleaned the engine inside.

It starts an sounds perfect and drives great now :)

I ran it for an hour after the rebuild, but there is what I think is a lot of debris in the Olie mesh filter and on the magnetic plug?
Is that normal to a Husaberg?

The cam chain tensioner was also broken after my ride?
I don't now why i broke?
Click to expand...
It seems someone made a `mechanical`timing chain tensioner out of the existing one?
Either way the tensioner has got a 10mm hex screw normally.
Seems someone altered it...maybe there was too much pressure onto the tensioner blade and the tensioner snapped...?
 
I had this issue and luck was on my side. The engine didn't have a rattle, a small oil leak on the head gasket. Hence the reason for removing the head. I also didn't like the look off the oil. So glad I did as it could have let go at anytime and cost me a fortune. Thanks Taffy for the new cam chain.
 

Attachments

  • IMG-3474.jpg
    IMG-3474.jpg
    1.9 MB
  • IMG-3475.jpg
    IMG-3475.jpg
    1.5 MB
  • IMG-3477.jpg
    IMG-3477.jpg
    1.2 MB
  • Like
Reactions: ThomasB
Not sure, the bike has been rebuilt in the past. I just know I'm lucky it didn't let go on me. I purchased the bike cheap but I never got round to riding it in anger.
 

Similar threads

S
2004 FS650 - Aluminium shaving in oil filter
Replies
7
Views
1K
Samuel42
S
C
For Sale: 2008 FE 550 - Restored and Adventure-ready
Replies
0
Views
2K
canadius
C
C
For Sale 2008 FE 550 - Restored & Adventure-ready
Replies
0
Views
499
canadius
C
S
Cam chain tensioner and blade issue.
Replies
5
Views
1K
Spuddy18
S
Taffy
New - improved carb needle 2004-2008
Replies
3
Views
2K
FlyingZebra
FlyingZebra

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions