This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Carburettor settings

K

klemen-SLO

Joined Jun 2002
26 Posts | 0+
Bled, Slovenia
Hello.

I had to put apart a carburettor (Dellorto) of my 2001 FS650e.
Unfortunately, I have lost my notes about idling and mixture screw settings.

Does anybody know the approximate settings (how many turns)?

I think that mixture screw is around one turn, or so.

Thanks for your help.

Have a nice day.

Klemen
 
Re: RE: Carburettor settings

Gokai134 said:
Klemen-slo,

look into the owner-doc/carburation/dellorto
Everthing there
Click to expand...

Almost. Sometimes the simple is overlooked ... Which direction leans the polit/starting circuit is not there. Could this be added to the doc?
 
RE: Re: RE: Carburettor settings

the screw is i believe an air bleed screw so the more open you screw it = the more air enters to make it leaner.

i believe the doc dopes explain how to set the carb by ear for the first time which is how you should do it anyway (ideally).

to recap:
get it running
adjust air screw to gain highest idle
lower idle to correct rpm of 1,800rpm.
adjust air screw again
adjust idle screw again for 1,800rpm (or abouts)
test ride noting any 'bog' and adjust the air screw to eradicate this. it should take about 1/4-of-a-turn either way.

regards

Taffy
 
RE: Re: RE: Carburettor settings

If you go to the download section at www.husaberg.se, you should be able to print the old parts manual. At the end, it tells you how many turns out for the idle and the mixture screw. Usually around 5 out (+/- 1) for the idle and between 1 1/2 and 2 out for the mixture.

Then what Taffy says.

Check the download section on this site, for the 4 videos. I think the first one shows how to adjust mixture and idle.
 
Round slide Dellortos use a fuel mixture adjusting screw and flat slide Dellortos use the air bleed adjusting method.
dan
 
i really must try and remember that. infact i'll go check the doc now coz if it's wrong in ma hea you know it'll be wrong in the doc!

ah! i had it right in the doc it's jus ma hea that needs a sortin oot!

regards

Taffy
 

Similar threads

G
CARBURETION ADJUSTMENT PROBLEMS FE 450 2005
Replies
0
Views
45
GMC77
G
A
Carburetor settings 400FE 2002
Replies
4
Views
731
Anjeba
A
Taffy
sledge plates manufactured and back in stock
Replies
0
Views
446
Taffy
Taffy
W
2010 Fx450 crank no start after engine work
Replies
3
Views
477
waylon
W
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
418
rikschipp
R

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions