I just had a major rebuild done on my bike and after assembly, it starts and runs fine with the idle speed adjustment screw pulled out, but immediately dies when it is pushed in. Before the blow up, the bike started flawlessly every time with no need to pull out the screw.
I can get the bike to run with the screw pushed in, but it sounds like it is starved for air and doesn't respond well off idle.
The injector was replaced with the rebuild.
Any ideas?
I can get the bike to run with the screw pushed in, but it sounds like it is starved for air and doesn't respond well off idle.
The injector was replaced with the rebuild.
Any ideas?
