don't know what's wrong with my bike - Fuel pump, TPS, Valves?

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Feb 10, 2024
Messages
4
Location
Sweden
My Husaberg FE 390 2012 got some problems out of nowhere. It has an uneven idle and dies during idle both warm and cold (have tried adjusting the idle speed but ), "boggs" when driving with a steady gas but runs okay during slow acceleration but "loses" power when given full gas. Just like the fuel doesn't go through or is blocked, then it dies sometimes when during downshifts but I can always start it up again without any problems.
Anyone that knows or thinks they know what the problem is and what the solution is?
 
Does the FI light come on when it acts up? Other quick things to consider is the TPS (throttle position sensor) adjustment and functionality, fuel starvation (usual causes are small filter inline before fuel injector, or main pump in the tank, poor grounds, etc.
 
No, the FI light doesn't come up I will try to look into the TPS but I'm trying to find out what voltage it should have stock. The pump itself seems to do okay I'm starting to think it's the regulator or the filters.
 
If it has a seperate tuner that intercepts the fuel injector wires, try by passing it, and connect the stock fuel injection connector onto the fuel injector directly (like factory).
 
Start simple: make sure you have good, fresh, 94 + octane gas. Don’t mix it with old crap!! Replace or remove the little in fuel line filter. Then question the in tank filter and/or pump. The pumps were known to go bad prematurely because of the extreme heat from the nearby exhaust.
- A 2011 390 guy.
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions

Back
Top