problem

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. K

    ***NEW 2010 390 ELECTRICAL PROBLEM***

    When I try to turn on the engine with the magic button the bike does not turn on, the spark plug it is not getting power (spark), I checked all the connectors, cables, battery, etc and every thing looks good, if I push the bike it turns on very fast and the FI light it does not give me any error...
  2. G

    04 FE650 starter problem

    i bouth me the berg about 2 weeks ago. suddenly it will not start anymore on the E-starter. Nothing happens if i push the button (didnt hear anything). battery is new, and the cabels on the starter relay are not damaged. (fuse is OK) and the orange light on the speedometer disapeared. new...
  3. 9

    Setting Tool Problem

    I HAVE ALL THE SOFTWARE ON MY PC TO USE THE TOOL BUT WHEN I PLUG IT IN THE BIKE IT DOES NOT RECOGNISE THE ECU CAN SOMEBODY PLEASE HELP ME WITH THE INITIAL FIRST TIME ON BIKE SET UP,THE BIKE HAS NOT YET BEEN RUN, DO I NEED TO RUN IT BEFORE THE UST IS USED.
  4. H

    SOS Start problem Husaberg FE450 2009

    Hello I have problems with my Husaberg FE 450 2009. Description of problem: When I push on the start button the start is very weak Its almost like the starter can‘t turn the engine and if I try again then Its a better start but it does not run only in perhaps every tenth time it starts very well...
  5. L

    Mixture screw problem????

    Hi all, I've a problem with my Husaberg FE400 2003. I can start my Husa easy with the kickstart, but i can't adjust the optimal mixture. With the motorbike started i can totally close and totally open (6-7 turns) the mixture screw, and the motor don't stop and have no sound change. I think it...
  6. X

    FE400 Carb Problem

    I have the above bike 2002 with the dellorto carb, the problem i have with it is after binning the bike, the carb floods it appears to have an over flow tube which is not blocked but the carb bowl does not drain. What may cause this? Any advise/info is appreciated Thanks Bob
  7. D

    3 phase rectifer problem?

    hi lads just got a 2003 fs650 with the battery and electric start removed and lights stripped.trying to get the lights working to put on road but to no joy.its fitted with a 3phase rectifier which having read the doc seems different than most.there is 2 yellow and 1 blue coming out of stator...
  8. P

    fcr 41 flooding problem

    tell me o knowledgeable ones... i have a fcr41 mk1 on my old 01 fe650. i have always had trouble starting the thing when it has been flooded,for instance if i layed the bike over on the side of a hill. starts not a problem,1st kick hot or cold,but flooded not a hope of getting the thing...
  9. A

    02 Wiring Diagram & spark problem

    I was going to ask if anyone had a wiring diagram for a FE 501 02 as I couldn't find one in the download section under user manuals however found it in the 2001 - 2002 parts manual, plus the exploded line drawings in there are great to use along side the workshop manual / much clearer than the...
  10. X

    New Berg owner as a problem

    Hi Guys, I recently bought my first Berg which is a 2002 FE400 so i have no ideas of their common problems. The problem i have is cold starting. I have already bought a new Stator and a big Battery from Taffy. After many kicks and winding her over with the e start for a long while she...
  11. T

    valves or timing problem

    I have a 2001 fe400 that had a camshaft bearing break and spit the balls throughout the engine. I found all of the bearings, replaced the broken bearing, broken balancer drive gear and put a new timing chain on while I had the engine apart. I lined up the dots on the new gear and placed the...
  12. Taffy

    sprague: the problem, the reason, the cure?

    i have had the sprague assessed by someone in the aircraft industry and i explain what are believed to be the problems and cures. on the husaberg, the inner spins with the clutch basket permanently. the outer only spins with the starter. on an aircraft engine, the inner gear and the sprague...
  13. Bif

    fe400 fuel or electrical problem??

    Hoping someone can assist with this. I have a 99 fe400 with super low hrs. It ran fine 6 mos ago, but now I have a problem with high speed running. It starts fine, choke on 2 kicks , choke off - 1 or2 kicks and it starts right up on idle. Throttle response is great thru 1st , 2nd, 3rd gear, at...
  14. H

    95 FE600 PROBLEM

    I HAVE A 95 FE600 IT WILL BLOW BACK THROUGH THE CARB BUT IT RUNS VALVES ARE SET CORRECT I HAD THE CLUTCH COVER OFF TIMING CHAIN IS TIGHT IT FLUTTERS WHEN ITS RUNNING ALMOST SOUNDS LIKE ITS RUNNING RICH WHAT COULD IT BE?
  15. T

    Hmm a problem with my 09 450

    I decided it was time to take the tank off and explore some. I have been very kind to my bike......with recession I have needed to spend more time paying attention to my business. Oh well that is how I pay for these two wheel treats The problem, page 65 of the manual shows that you must...
  16. T

    Need help solving headshake problem with '06 FE450

    Headshake problem with 2006 FE450. This bike is twitchy and loose, gets headshake from the slightest interruption. I've checked damping adjusters, tried multiple clicks in both directions. I've increased the rear sag to 60+ mm. It does get better, but is still terrible. I swapped out the forks...
  17. H

    Husaberg NEWBY - estart problem on 650fe

    Hi all, I am recently become the proud owner of a 2005 fe650 berg. Before I purchased, I had never riden or even seen one... I have had the bike for about a month now (and love it) BUT having dramas with the Estart. When the bike is cold, and when attempting to start via Estart it will...
  18. E

    Is this a problem (shift drum)

    Will this give any problem when used in an engine?
  19. F

    Husaberg 650 02 Rocketarm bearing problem

    Hey The bearing on the rocket arms has blowed on my Husaberg FE 650 2002 I have took up everything and it seems like the eninge is ok accept the bearing. Also held out the oil and looked very nice. Anybody who have experienced this before? Is it safe to just change the bearing and...
  20. H

    Starting problem Husaberg 650 2002

    Hi! I have some problems starting my 650, both warm and cold engine. I'm sure it's 'user fault' on my part as well. However, no matter how i maneuver the decomp, it won't start on either kick or electric motor. I have to run it downhill to start it, and then it seems to run just perfect.. Too...
Back
Top