problem

Hi, I have read heaps of the threads about this but I'm not too sure if I have something different going on or its just the same? I have a 2010 Fe390 3000km on it, never had a problem with the weep hole prior. But..... I just replaced the radiator fluid. drained all the old stuff out and put...

I picked up a 2010 FX450 for a great deal this winter. I decided to get it ready for spring, checked the valves, oil change etc. I disconnected the positive cable from the battery while I had the bike apart. After the service I reconnected the cable and tried to start the bike. The relay clicked...

Hi all. My 2012 FE 570 recently started to run bad after some 30minutes of riding, getting worse every ride and sometimes not even starting when hot. If I tried to decrease the input air-amount (clothing in airbox) making the bike running better and my idea was then that the problem should be...

According to these guys: http://transmoto.com.au/transmoto-exclu ... erg-fe450/ there was a problem with the upper engine mount on the '09 FE450 that was fixed in '10. Any idea what it was or what the fix was?

I bought this bike not running . It had carb. problem's I put a new one on it and it started up and ran great. Now it just depends on if it wants to start or not. Some times you choke it kick 3 times and it starts then the next time you might kick the thing twenty times before it will start. I...

So I just purchased a low hour 09 FE570. Wanting to start at a baseline, I was going through the bike and making sure all was good...So I start to change the oil and on the first drain plug I encounter what feels like a cross threaded plug. It is getting tighter as it is coming out of the case...

Hello. I have a Husaberg FE 501 from 1991. My front and back light won`t burn for a long time. In the front I have a 12v H4 55/60 watt lamp and back a 12v 21/5 watt lamp. When I measure with a volt meter parralel on the lamp I measure 8, 9 volts AC on idle speed en full trottle 12 volt max. If...

hey, im Gøran and im new here. i just bought a husaberg fe 650 and i love the bike, but i have one problem. i didnt notice it at first. but the bike gets engine oil from the engine breather hose. this only happends when i drive it hard or does max speed, after i go max speed i notice straight...

[attachment=0:qtkm3la9]husaberg.jpg[/attachment:qtkm3la9]Hi i have recently purchased a 95 husaberg fc 600 it was running fine and started fine just needed a valve adjustment .I got on with the valve adjustment 1mm both intake and exhaust which i got told is right?. started the bike up it ran...

Hi guys, im the proud owner of a Husaberg FE501 2003 model. I have no spark and my starter motor is not turning the motor over, it's making a slipping noise and then grabbing every now and then, I removed the starter motor and the teeth seem to look fine. I have tested the coil and can confirm...

So I have a 2011 FE 390 my problem is just on the last ride I stopped and pulled over with the group, then I went to start the bike and take off the bike started and then couched and stahled I tried to start the bike again and all it did was turn over almost like it was out of fuel. I know it...

Hi The gearbox of my 02FE400 works great without any strange noises, my problem is with the 4th gear. In 4th gear and when I push it harder it will jump to 3th gear, it doesn't make any strange sounds or anything, it just comes to 3th gear. If I don't push it harder it doesn't jump. It's been...

Hi all Husky/Berg fans. After changing clutch friction plates on my 570-12 the clutch no longer works... (Before OK). I have rekluse EXP2 and of course I thought I had done something wrong but all seems to be correctly installed. The right no. of friction and steel plates (6pcs) are installed...

Hi Looking for advice on fixing the problem with my FE 570 '09 EU model. Yesterday I pulled at the gas station and by the time I rolled to the fuel pumps bike has died. I refuelled it and wanted to start it up but with no luck, it cranked as it should but wouldn't fire up. I had to tow it back...

(07 Berg 550FE) First the easy question, in the manual it states to use DOT 5.1 brake fluid but then on the side of the bike (near rear brake reservoir) it says to use DOT 4 brake fluid only...ok, so which one? Secondly, just bought this bike and took it on first ride and was only riding for...

Hi, I bought my Husaberg one month ago. I got problem because bunch from speedo is cut so I have no idea how to repair it. Can anybody help me? This is picture of cables inside of speedo http://img713.imageshack.us/img713/5366/speedox.jpg Thanks a lot Ted

[attachment=0:2aqb667l]mms_picture.jpg[/attachment:2aqb667l] Hi, this is my first post here, so good to be on the site. Here is my problem: I bought this used 2011 FS-570. It has a slip-on pipe and has been re-mapped by Two Brothers Racing. All 4 times I have rode the bike around town it...

Hello all I'm new here, and I arrive with a problem. I have a FE 400, year 2000 model, but build in 1999. It's the third time I have electrical problems. The cdi was repaired once and the stator twice... this is starting to make me a bit sad with the bike. Looks like she doesn't like water...

has anyone else had the problem with the "O" key button on the digital speedo, my button has to be pressed very hard and on different angles to get it to work, it drives me mad, sometimes it just doesn't work at all. i use trip 1 is for keeping an eye on fuel and trip 2 keeps an eye out on my...

Hi I'm new in this forum, was reading it for a long time. I both a used FS650 a few days ago, with one problem: she don't start. I thought it might be a little problem, stator or ignition coil. Today I tested the Stator: 3k ohm on red & black / 170ohm on green & black When Kicking: ~30 Volt...