Hi
I have a 99 600 FX basically all rebuilt [bought as a basket case ] anyway she starts no problem when it is cool ,push the button and it usually fires to life first time. The problem is once it gets hot it will fire but as soon as you apply the throttle just a smige it flames out and will...
My 2000 FE600 starts fine (kick) cold with the choke on - 2nd or 3rd kick. Its ok hot sometimes. It was a problem hot but I found if I switched the fuel off before the engine it started ok - on investigation I found one float full of fuel..replaced it..needle & seat seemed ok > that improved...
Hello all, Looking for help. I picked up an fcr 41 mm pumper second hand
and just installed it.My husaberg is an '02 fe501e. I can only get the bike to
start and run with my hot start wide open...
hello,
well after all that idle troubles,now the bike after hot it wont start :(,it starts pretty well when cold.
i must go down climbing to get it started.
the valves is checked,and so all the rest...electrical?mechanical?
pls any advice...
alex
My 95 FE501-suffers from power loss when hot. The bike is set up as a supermoto. After about 8 or 9 laps (about a 1 mile lap) the bike starts to lose power and misfire abit. When I slow down the bike will cut out and will be impossible to restart for about 15 minutes. The bike will restart when...
Hello,
I have a 96' FE 501 that I purchased at an auction. After giving it a good inspection I found it needed a new stator. The stator was replaced with a new unit and the 40 mm PHM was re-built. The bike now starts with about 2-3 kicks cold and runs like a rocket after I played with...
2002 FC470e. The bike does not want to idle after a long moto(20mins). I have the idle screw almost all the way in. Other than this the bike is perfect. Starts and runs fine.
I noticed this after a stall. Any ideas. The bike has about 20 hours and is stock.
Thanks
Les
Just been on a race school all day Sat and the Berg was ace 650 03 Supermoto. After a few kicks first thing it started on the button all day. Only problem was a couple of times when it was really hot that it seemed to turn over one revolution then stop (sieze up) prod the button again and it did...