fe650

Anybody have drawing of where the cables from startor to the regulator goes? The yellow ones and the blue?

I am sure this has been covered, but could not find this specifically. I am needing to replace the starter clutch and cannot remove the H2O pump impeller after I removed the clip. Any help please. Thanks!

I wonder if anyone can give me the exact measure from top to top of the torque limiter in the picture below. It's a FE 650 2007 model Thanks a lot

I have an '06 650 Berg , with a full Titanium Akrapovic exhaust system , that has been cartwheeled and damaged the section of pipe just before the muffler . Does anyone out there have a replacement section , either new or used , that they might want to sell ?

I plan to ride in So. Colorado in July with a buddy. We will be hitting a few mountain passes. A few years ago I was near Frazier CO and the jetting was way too rich. Does anyone have recommendations? I am currently at about 1000 ft. in TX with the following settings: Carb: FCR 41...

I have an FS650, want to set it up as an enduro/offroad bike. I will keep all the supermoto stuff to swap back. I need a FS650 swingarm and shock to finish this off. Also, I do not believe the 450/550 swingarm shock will work on a 650? Thanks

I have a 2008 Fe 650 with 32 hrs that just started to have this problem. It cranks over for 2 seconds then starter gear must just pull in and spin. It kicks in on the initial button push but after a couple of cranks it pulls out and just whirls. I've searched some of the forums and see a mention...

Hello guys Is it posseibel too put a 30w led bar on my FE650 -01 whit sem igniton? Im have led tail light and original in head light Is very dark here in Sweden at this time on the year :cool: Regards Mikael

I lost the battery box for my bike and no luck on ebay so far. Not sure what years fit. There is a 02 battery box on ebay but only one pic so can't be sure it fits. Thanks for any help.:)

Hi All, I only want the starter button and kill switch/charging circuits on my bike. I have taken off most of the wiring and all the lights etc. Just need to know how to connect the reg/rec to the circuit to charge the battery now that the wiring loom has been disconnected. Can any of you good...

Hi My bike doesn't start. I suspect the compression is to low. Does anybody know what the compression values are? My plan is to measure trough the sparkplug hole. Do i have to disconnect the decompression device? If so, is it straight forward or any problems doing that? Mvh hauge

I am looking for a valve cover for my fe650 from 2005. The valve cover should be the same of the 450 and 550 models from 2005. I need the cover without the waterpump on the cover.

I just finished rebuilding the bottom end of my 2006 FE650. The auto decompression stopper (hot rivet) backed out and snapped my cam chain. Damage wasn't too terrible, but I ended up addressing the flooding wore items: replating the cylinder, new Wossner piston, complete rod kit, both main...

hi ive had an accident and been on crutches for 8 weeks so the bike hasnt been run much, but i did the oil & filter and been cleaning it (as ive not had much else to do) started it up the other day on choke, ran fine, choke off, rode down the street and it bogged out after a couple of...

Hi guys my name is Ray I'm from Australia and I recently took ownership of an 04 FE650 with just 51 hours and 2600kms on it. It did however have a flat spot down low in the revs. After inspecting the carb I found that the accelerator pump nozzle was blocked, after many hours of trying I could...

Hi guys, I've seen a 2005 FE650 for sale with a seized engine, that had 8000km... I am thinking about buying it, if the bid doesn't go to high, My question is, do we still find all necessary parts to rebuild the engine, and has somebody an idea about how much it would costs to buy all...

Hello everyone im Wes and a newbe Im in the process of buying my first Berg,ive had multiple ktms over the Years but this is the first Berg, its a 2007 FE650 4500km 80 hours bike looks in Good shape, i believe the crank bearings is the week point so i have read and the cranks apparently...

I have been unable to sell bike so parting it out if get interest. Make me offers. It complete ready to ride right now so it's all there. Txt me is best. 605-3802423

Hi I have recently bought a Husberg fe650 2003 and it doesn't start. I dont't get any spark so i was hoping someone could point out any possible solution to my problem. I don't have much experience with this, so bear with me. Thanks

can anyone tell me best engine oil to use book says either 5w/40 or 10w/50 fully synthetic oil will any make be ok like Castrol magnatex or another good brand any ideas please my bikes a 2004 and I don't want to blow the motor also whats a good oil for the foam filter thanx mark