fe400

I just picked up my dad's 1998 FE400 that has been sitting in my mom's garage for the last two years since he passed away. I did a quick carb clean, cleaned the fuel tank and put on new fuel lines and got it started up the cheater way by hooking it up to a car battery. I'm pretty sure it's a new...

just brought a nice 2003 fe 400, has the dell carb on , starts of the button and kick easy , problem is it seem to be drinking fuel , runs great but lacks i think from top end(think runningout of grunt) what u all reckon , should i just ditch the carb and get fcr, rebuild the dell new jets etc...

I was hoping someone would be able to help me out with the measurement for where the tensioner sit in the head. Following the explosion of the top end I've finally got it welded up but lost the location of the bolt for the tensioner for a 2002 fe400 head. If someone could help me out with this...

hello again! I'm in need of a new clutch basket and primary gear. I have found these on ebay wich is supposed to fit. However my primary drive does not have a keyway slot. And the clutch basket on ebay has a needle bearing while mine have a bronze bushing. will this be a problem...

hello all, I just bought a 1997 Husaberg fe400 and its a blast to ride. the bottom end has a ton but once I get half way through the RMPs it starts to bogged down really bad.... I am new to Husaberg so I don't know much about them mechanically. my guess would be these bikes are geared low for...

Hello People! I have been working on my New husaberg fe 400 2000 for some months now. Its soon time for the road and hopefully it Will withstand some commuting. I have some minor problems though I 1. The electrical start wont start the bike when its cold. Is this normal? Starts pretty easy on...

I'm trying to find parts for a 97 fe400. I'm having no luck so far, if someone on here could point me in the right direction that would be awesome. I need a rocker cover and a few miscellaneous other parts.

My fe 400 has developed quite a loud knocking, it started quite suddenly so I stopped riding it and I'm using my other bike for now. I've recently stripped the casings as I had a problem with the camshaft beairings collapsing, it rode fine for a few weeks after that, now it's started knocking...

So a bit of back story before I get into it I was having major problems with the bike fouling plugs within minutes, so I decide I'd take the plunge and change to the FCR ditching the problematic dellorto, had troubles with the switch but finally had it running and running well with the FCR...

Missing parts FE400 please help me!!!

Hi people, Im having a bit of an issue with throttle at the moment, ive just replaced all the jets, gaskets and seals on my carb, it runs good BUT.....I took it round the block for a quick test run and when I hit full throttle it stuck on?? As you can imagine I was a little shocked, i pushed it...

Im having trouble with this bike it seems that it needs more wrenching in hours than i ever get out of it riding. Are these bikes just throw away bikes from the early 2000's? Cant seem to justify the expenses of fixing for the short time riding it. What does everyone else do with these...

Hi, names Kevin and I've been riding my whole life. Started on an; old Honda 80, moved up to Kaw Kdx 250, then a Ktm (2 stroke)350, to a Husqvarna wxe 350 finally decided I'm quite happy with my slightly used 99 fe400 Berg. Completely refreshed whole bike and made street legal. Love my Husaberg...

Hi I have a 1996 Fe 400 and i cant find front or rear wheel bearings or even the sizes! If you have any ideas let me kow. Tanks Taylor

My 1997 fe400 has a KTM speedometer on it. Is this the correct speedometer? If not, does anyone have the correct part number or maybe even one I could buy even used with hopefully over 8000 miles on it ( I'd like to match somewhere close to the current miles if possible). 209 931-4151 if you...

Is there a vender where I can purchase the number plate backing for a 2000 fe400? Thanks

Hi,could someone please tell me how the dellorto choke lever works?is up full choke or is down full choke.I've read what I can find and cannot find the answer and at the risk of sounding completely inept I'm asking.I just bought the bike and am excited to get out and ride it.I was very excited...

Hello all, I'm new to this site and husabergs, so sorry in advance if I do something wrong. (The signature thing is saying I've exceeded the max word limit of 0) Just bought a 2003 Fe400 supermoto and it's pretty different from what I'm used to (85' Yamaha XT350). I've been looking to update it...

I have taken the plunge and bought a 2010 390. First impression is that there are some similarities to my old FE400 starting with riding position (high pegs). The "new" engine is way smoother and the throttle response (F.I.?) is way better. Also bike feels really nimble which is what the 70...

Hi all, Sorry if this was brought up before but i did not find any answers... I have a friend who just bought a 99 Berg FE400 and he has a problem in his hands...From what we did understood, is that the DELORTO carb is a pain in the a$$ and we tought that we might as well change it with the...