fe400

Good afternoon to you all im new and i have a husaberg fe400 from 98 e bought it about half year ago i did normal service and rode it in the summer a lot on the dirt for about 2 months after that when it got hot it just stall and died and i couldnt start it by foot only with pushstart like...

Good afternoon to you all im new and i have a husaberg fe400 from 98 e bought it about half year ago i did normal service and rode it in the summer a lot on the dirt for about 2 months after that when it got hot it just stall and died and i couldnt start it by foot only with pushstart like...

Is it possible?with cylinder,piston,crankshaft

Hello all :o My bike fires fine on the kick but Will not start on the button at all??? I have replaced the battery with a "beefy" Lipo type with around tree times the cranking Amps and upgraded the wiring since the battery now sits under the Seat... It turns over but Will not run at...

Hi all Currently own a 650 supermoto but seen a cheap fe400 and thinking about getting it to have a play on the dirt with. Is there anything specific to look for with these? Anything prone to breaking? Or are they just husabergs and a pain as standard? Thanks Sent from my SM-G950F using...

Hello everyone I'm new to the forum I have a 2000 FE400 with 89 miles on it that I'm at the crossroads what to do with I'm looking to trail ride with my wife and kids but want a bike that I can still get parts for. I am a mechanic so won't need much support there. Looking for advise on what...

Need some help guys, I have a couple of broken spokes on my 2000 fe400e anyone know the best place to get spares (I'm in Melbourne Australia) or anyone have an old buckled rim I could get a couple off Cheers

Hi all just got my bike running but it will start when cold but as soon as it is running and it stops it will not start up again it won't even try and start anyone help thanks

Hello i am looking for a big tank for my FE 400 of 1998. In particular I'm interested in the model produced by HSB with capacity of 19lt. art. N ° 390036-01. Thanks so much.

Dellorto carb all recommended jets main#185 needle #dr270 pilot #33 start #45 tried #40 but holes at bottom in bowl the 45 the holes at the top no improvement with #40 clip 2 ,1 turn out on mixture screw new float and float needle and seat ,needle is k51. Issue is fouling plug when choke used...

Hi all, My fe400 has a fcr mx 39 on it. The bike is new to me and has a major problem with hanging idle. It's either reving high, or stalling. It's a real nightmare to ride at the moment. Where should I start? Thanks, Chris

Hello. Tell me please what model KTM stand the same clutch as the fe400 husaberg 1999?

For $1200 OBO. My dad bought this in 2007 and had a full engine rebuilt in 2009 then it mostly sat. I would bet less than 50 hours on the engine. He passed away a few years ago so I picked it up and got it running by cleaning out the fuel system/replacing fuel lines. Changed the oil and coolant...

Hello husabergers, I'm looking for parts for very old FE400 (pre 1999)? I'm interested in Rocker Cover with rocker arms (200013); Valve shaft with gear and water pump; gear wheel crankshaft/clutch hub; if you have and wish to sell them - please contact me to aslabada <at>...

Hello guys. I am in a little chaos here trying to find a water pump impeller for my bike. Does anyone know of any place that would have it or any other bikes that the parts would fit like ktm or Husqvarna? Any help would be appreciated.

Hi all, was out on the bike on Sunday and noticed an intermittent "chinking" noise. After a few hours riding it bogged down on me and eventually cut out and refused to start. Pulled the plug out and it was soaked so stripped and cleaned the carb to start with, no joy. Gave Taffmeister a...

Kijiji ad says it all, email for details/ more pics Husaberg FE400 supermoto (FS400) | other | Kitchener / Waterloo | Kijiji

just finished the basic first testing on my 99 fe400 drz ignition swap! starts better than new,timing advancing, great throttle response! really quite a simple swap! i'll try to post picture soon!

Hi, Trying to locate exhaust valves and springs for 1999 fe 400 have not had much luck. Thank you Ray

Hello I'm a new member and a first time owner of this bike. Looking for any type of manual. Thanks