exhaust

Hi. Anyone knows, where I can find parts for an Akrapovic exhaust from a Akrapovic complete system? I need the steel band for my exhaust

Hello all, As the rebuild is almost done, I noticed as I was running the motor for a minute or so that I had melted the carb vent hoses, as shown below. Those hoses are just PVC or polyurethane (I can't recall which) to replace the old ones. I think the temp rating is only around 70C. I...

I'm curious as to whether the pipe on my new bike is a full system or just a slip on. The can is Akra too, but this doesn't look like the header I see available. Given the heat shield, and hardware not matching KTM stuff, I'm thinking it probably is but want to confirm.

Hey Folks, searching an SR-Racing Double Silencer Exhaust for my Husaberg FS650.:devil: make me an offer with shipping to germany please in private message please. greetings & regards

Adjusting my clearances 1/6th turn but the exhaust side rocker arms don't move or click like the intake ones do... Can't be right can it?

Hello berg lovers. I need your experience about carburator jets. After I have installed akrapovic exhaust and DNA air filter on my fs650e I began to feel the bike a bit strange and low throttle response. I have pushed the acceleration pump a bit and looks better. Couple of days ago a guy with...

Hi Guys, Searched for this but can't seem to find anything! Whats the deal with 650 Berg Exhaust? I know we can get most end cans with a 60mm inlet to fit on my akra mid link but ( i don't have a standard mid pipe to know the inlet size!) But is there a complete exhaust system that will...

Hello, I read in a forum announcements that it was possible to mount a 390/450 collector on a 570, I could find a titanium collector of 450 and here's what it gives however, it will be in French: : the installation is difficult and there is a lot of stress; it touches on the front part of...

Hi I'd like to change the exhaust now.:mad::mad::mad: I do not have anything on FMF. Do you know any sites you can buy?:cry::cry: I do not care if it's akrapovic. Do you know? It's 2008 year.

628cc If you were to design an exhaust system from scratch, ideally where would you join the twin header pipes to the collector? How would power and torque change if the join was made close to the head or a long distance away? Many thanks

Hello, I'm looking for a after market exhaust for my 2003 FE 650. I'm in the UK so must be in the UK or willing to post to UK. Thanks Amy

Hi everyone. I've recently purchased my first berg. A 2003 FE650, I'm using it on road with 17's and bigger caliper. I'm looking to upgrade the exhaust, currently standard(I think!). It seems almost impossible to find one specific to my bike! Does anyone know of any that fit or know...

Exhaust central Manifold Compatibility husaberg 2009+ FE vs FS Hi everybody By looking at the number of the central/manifold part, I realized that there were 4 ref no ..... For the 390/450/570 FE: EU model with lambda sensor: 81205008000 US / AU model without lambda sensor...

Anyone got a left hand exhaust header pipe for 501/550? It's for an 02 FC550, but I believe they're same for all years 501/550cc. I've got one but the sleeve section that fits into the cylinder head is gone from the L/H one. Maybe I can get a bit of tube welded on, but would be much simpler if...

I have been planning on making a stainless steel dual exhaust for my 650. Mostly for looks, but it would be nice to make it bring some power too. It would use two Akrapovic silencers. Since the SR Racing dual exhaust has been praised as one of the best aftermarket exhausts, it would be easiest...

Just picked up a '10 FE570 that has a full Ti exhaust. I found the O2 sensor covered with a rubber plug and taped up zip tied to the front frame rail Obviously with no bung for it in the Ti FMF exhaust they had to do something. But should I do something else with it... Like remove it...

Looking for a Exhaust silencer for my 2011 Husaberg fe570. I am going to take it hunter in November in the desert. I would like to make it a lot quieter. I was looking at the Akrapovic Titanium Factory Header Husaberg FE/FS 570. WOW!! I lot of Money!!:eek: I know there has to be something...

Hello everybody, because season is going to an end, project thinking starts again. My 07 FS 650 still has the original exhaust. I ride only track/supermotard. Now I'm looking for pros and cons for the following: Akrapovic titan vs. double muffler exhaust. The Akra is looking great, will...

I recently picked up a 1999 Husaberg FC600. It has the factory head pipes, but the previous owner fabricated his own muffler. Although he did quality work, the muffler is too short and the outlet is too large - it is way too loud, and just sounds bad. I picked up a Laser brand muffler off...

Good evening! Noob here! New owner of 09 450. It has an akro exhaust but the front carbon hanger is broken. Can someone point me to a similar piece? Ktm? It doesn't have to be carbon but I can't find much on what to order. Thanks in advance.