end

should i check my end float first or run it in

Hi all, Who has a definative answer on the proper crankshaft end play/axial clearence for the upgraded cylindrical roller main bearings? The motor service guide states for the 2003 crank with roller bearings that the clearence should be 0.25-0.30mm for 400-550cc engines and 0.30-0.35mm for...

Hello everyone this is my first post as I'm still reading through all the info on this great site!. I've just aquired a 2002 FE400 with a Rino end can fitted. I was told that no adjustment to jetting is required so can anyone verify that this is correct? cheers

Hi Guys, Anyone know if any quiet and road legal rear Silencers are available. I am in the UK and want to do some trail riding but the standard Silencer spooks the horses where i ride. If not is it possible to get the original pipe baffled. Thanks Colin

cadmere end raced yesterdayin thick rain AND had to run a trials tyre on the rear to boot. two 1.5 hour sessions and in the first i was riding well and only overtaken by one rider, a sidecar outfit and about 3 quads! unfortunately i feel at a downhill left and it wouldn't start again...

one of my rocker end caps appears to be leaking oil. from the drawing i'm guessing the o-ring is the culprit...maybe it's cut. can these end caps be removed without removing the rocker assembly? doug

Hello all, I am contemplating removing my top end to take a look around for wear and/or anything unusual. I have about 50hrs on the engine and I would like to check for any signs on wear before I have one of these, "Stuck out in the middle of no where" situations. Can anyone give me any...