2003

Need some help due to total lack of Berg knowledge.Have re-silicon-ed rocker cover,replaced valve inspection gaskets.Bike now seems to be oil tight-ish from here,but it is definitely looks to be seeping around the head gasket,cam chain side,approx below the radiator hose,this seems odd surely it...

Anyone with any info would be helpful due to my overall lack of Berg knowledge.Have re silicon-ed my rocker cover,replaced the valve inspection gaskets,they seem to be oil tight ish but there is still a definite seep from what appears to be around the head gasket ,next to the cam chain housing...

I can't believe it,I've owned this bike for approx 4 months,battery failure,starter failure,leaking gaskets dodgy kick starting and now no spark.Strange thing though,love the bike and the fabulous "design characteristics".I followed the thread on the site but still a bit unsure on a couple of...

SEM ignition SEM's charging coil replacement Starting Problems 1995... SEM ignition stators SEM regulation problem Question about ignition coil General Ignition info More general info Rectifier/regulator problems Rectifer Charging Circuit (good reference for rectifier and regulator...

Hi all hope somebody can help with this problem as I am starting to get really frustrated. The problem started with the kickstart not engaging, the kickstart would go through the whole stroke without engaging and then return up as it should with the return spring. when the engine was cold i...

You've probably all been here before but whats the best battery to fit an FE400E,something with a bit of grunt and without having to modify the battery box.Rumor has it a Yuasa YTZ7S will do the job?.I just need to know if thats the case, will it fit without any mods and, will the cover still...

Hi there,new to the site,new to husaberg.Have a cooked starter ,wondered if anyone new of an equivalent non Husaberg starter that will fit.Have tried a R6 same part no sm14 but too long,help.......Regards Matty

I recently purchased my first MC since 1985; a 2003 fe501e and it runs great, and is a blast. I took it out yesterday for the first time, and rode with some friends. In the Las Vegas Desert. I was told my compression release seal may be leaking a bit, gas is leaking from above the spark plug and...

Hi peeps Anyone out there know if an exhaust (header and muffler) off an 2001 FE501 will "bolt straight up" to a 2003 FE501 or an 04 FE450 for that matter? Were there any changes that would impede the chang over? Any help is a help Cheers

i have just taken delivery of a 2003 fe650 hus have done all the checks plug gap/valves but forgot to ask about the start sequence on it can eny one help? it has a manual decompretion leaver and no starter fitted so kick start only

Bike bandit has has part listings for 2002 and 2004 husabergs but no 2003??? when it comes to air filter, wheel bearings, sprokets, ect... is the 2002 or 2004 all the same???

My 2003 FS 650 E has been at the top KTM dealer in south africa 4 months now. It went in for a service and they test rode it and gave it the thumbs up. 3 days later I sent it to KTM's sales dept to sell. Two weeks later the sales man said it's smoking, so I booked it in to the workshop. The...

My 2003 FS 650 E has been at the top KTM dealer in south africa 4 months now. It went in for a service and they test rode it and gave it the thumbs up. I sent it to their sales dept to sell and 2 weeks later they said it's smoking. I booked it in and they said the pistoon was cracked and the...

Hi all just got back from a ride and did the usual ignition cleanout and lube. I found a couple of bits of very thin material in the bottom of the cover. The bits have come off the side of the flywheel and appear to be a compound to hold the magnets on. If you have a look at where the timing...

I own a Honda XR 650 that has a pipe, stage two cam, carb work, and suspension. Do you guys think the Fe 650 is a faster and better all around bike? I do alot of single track and open desert riding and my Xr is too heavy for the tight stuff

I have located a 2003 FE650 as new condition can any one give me any feedback for this model good bad or indifferent. I have been told it is in standard trim all original. Cheers Sparks.

Hello, I'm the new owner of a 2003 650 Fs, I did some research about newer Husa's, I learned that pre 2004 Husa's weren't really known for reliabilityand offcourse i wanted a post 2004 bike, but the lack of money 'forced' me to buy a 2003 Husa. So now offcourse i'd like to know what the weak...

Sold

I have read different things about KTM Stators working with Bergs? Is it true? I want to get a stator in Canada, but I have a KTM dealer in my town, and is was in stock, that means I can ride this weekend. So if its true, could someone let me in the the part number? I know its a shot in the...

please help. recently as documented on another post i lost a tappet nut. luckily this was recovered and had done no damage at all. did have to replace the inlet rocker arm as one of the screw threads was crap. nothing else was touched. bike will now not start and is at the dealers...