Hi just woundered if any one can help.Iv got a 650e supermoto that started life as a motocrosser the stand has been modified (shortened) and the spring eyelet hole (or whatever there called) on the stand is in the wrong place.Does anyone have the correct measurement from eyelet to eyelet so I can use the origanal spring`s .Thanks
"Idle" a member here was quite helpful when I had a few q's about the sidestand
Unsure if any of this is helpful you tou
Unsure if any of this is helpful you tou
Some pics to make sense of the above text.
I measured 40cm from the center of the sidestand bolt and marked the center of the tube.. Then from there, it's 338mm to the boss for the exhaust hanger. Or actually I think you can just make sure it's parallel to the left side subframe tube. I dint want to take off the seat and plastics to check. Maybe I have a pic on my pb without the rear section.
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
