- Joined
- Nov 7, 2016
- Messages
- 276
- Location
- chester
a few more detail pictures,
---- i have made a rear brake brake last winter to fit it upside down (it's an overkill set up and i might end up re-sleeving the rear brake master cylinder if that's the case)
---on the front clutch i have made a new clutch sleeve way bigger than the original so i can fit my nice isr leaver without problem (using the original sleeve was way to stiff)
---the 3d printed panel have been painted and polish and they look like nothing from a 3d printer
----with the cdi project everything is going fine ish, i only had problems using the nextion screen so i have been scraping the lvgl library and made a nice set up screen from basically c code (without using any pictures for the bars and stuff, is all logic) the only things that is simulated on the screen is the RPM ( everything else is from sensor readings)
-the plan is now to fit it on the bike, possibly using a max9926 to visualize a nice fat and square signal from the pick up coil and convert it to a max of 5v so it can be read on the arduino, with that i will be able to interface it to the rpm logic and next will be the ignition
---- i have made a rear brake brake last winter to fit it upside down (it's an overkill set up and i might end up re-sleeving the rear brake master cylinder if that's the case)
---on the front clutch i have made a new clutch sleeve way bigger than the original so i can fit my nice isr leaver without problem (using the original sleeve was way to stiff)
---the 3d printed panel have been painted and polish and they look like nothing from a 3d printer
----with the cdi project everything is going fine ish, i only had problems using the nextion screen so i have been scraping the lvgl library and made a nice set up screen from basically c code (without using any pictures for the bars and stuff, is all logic) the only things that is simulated on the screen is the RPM ( everything else is from sensor readings)
-the plan is now to fit it on the bike, possibly using a max9926 to visualize a nice fat and square signal from the pick up coil and convert it to a max of 5v so it can be read on the arduino, with that i will be able to interface it to the rpm logic and next will be the ignition
Attachments
Last edited:
