This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Outer clutch hub for -02 bike

Joined Nov 2010
32 Posts | 2+
Finland
Just realised that one tooth was missing from the big sprocket in the outer clutch hub.
Now I need a new one, but the -02 bike seems to be a bit difficult. The original part number is H23014701 but its no longer available, so am I correct that the current part number is 80032000078 (OUTER CLUTCH HUB 03)?

I quess the older H23000201 part is almost the same, but the teeth on the sprocket are slightly different?
Can i use it if I change the sprague inner hub and the timing gears also (gear wheel crankshaft & driving shaft)?

And what about KTM´s, do any of them have suitable part?
 
The correct part should be on its way from germany.
It was a bit difficult to find since the part has no numbers on it.
 
This was copied from the workshop manual if I remember correctly and is in "the doc"


Transmission
The transmission was modified with a different tooth profile between 2001 and 2002. The easiest way to determine how the engine was built is to look at the counter balancers' drive shaft. The early shaft has a straight surface and the later one has a diameter change between the position for the timing sprocket and the drive gear (tapered).

The following gears are not interchangeable between 2001 and 2002/2003: Counter balancer, balance drive shaft, drive gears on balancer drive shaft and crank shaft and also the outer clutch basket
 
Good to know, glad I didn't buy the older part, even though the seller had all the three gears that roll against the clutch basket.
 
Delievery of the 01 models was very late. The line between an 01 and an 02 model is blurry. Hopefully you will receive the correct part.
 
I hope so also.

The guy I ordered it from seem to be very well aware of the differences, so I trust he sold me the right one.
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions