This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

O9 450 No FI lamp cranks but no start

G

gwp58

Joined Jun 2010
25 Posts | 1+
sunshine coast australia
Same old story came home washed the bike a week later tried to start as I do every week riding or not ,No go .
FI lamp doesn't light up but engine cranks.
I have read posts on electrical system and it seems the reg requires current from the generator to switch everything on ,something it seems to lack .
Ive checked the wiring visually ( pulled apart ) unplugged and plugged every connector ,no signs of wear near the shock (removed top bolt and had a good look .
unplugged kill switch wires etc

Nothing
how do I test the generator or the stator since it requires current to turn on FI .
Any help appreciated ..

Graeme
 
Its OK ! I found the problem, it was a broken wire in the loom near the battery .Three red and white wires connect in a shrink wrap plastic sleeve and one (the power relay wire ) had corroded off .
After locating the power relay up behind the head stem I found it had no power when 5-6 on the plug near the battery C/o Davo's thread . I traced it back and found the break.


Tilll the next drama .

Graeme
 
Very similar to mine but mine was near the shock,3 wires to 1 had pulled apart right inside the loom, tricky to find, and really simple to fix once you've sussed it out
 

Similar threads

W
2010 Fx450 crank no start after engine work
Replies
3
Views
477
waylon
W
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
418
rikschipp
R
A
Mother of all non start mysteries
Replies
11
Views
2K
alistairhenry
A
M
2011 fe 450 no start
Replies
4
Views
2K
mdp
M
K
Husaberg FE570 fuel/ignition problem
Replies
9
Views
4K
TomTom
T

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions