Longer pull throttle assembly?

mboygood · Aug 18, 2004

Does anyone make a longer pull throttle cable,assembly for FCR or Dellorto carbs?Easier in tight terrain with larger displacement engines to control power,thanks.

PowerFiend · Aug 18, 2004

You can cut the grooves deeper where the throttle cables ride on your throttle tube(You need to cut it so it effectively makes it a smaller diameter), or possibly use a Suzuki GSXR throttle tube(Which has a smaller diameter, at least to a YZF or CRF. I haven't compared to a Berg or KTM).

PowerFiend · Aug 18, 2004

NOTE: The above applies to the dual cable FCR. But the diameter reduction should work on the dellorto too.

mhambone · Aug 18, 2004

Check out these tubes. Might be what your looking for.

http://www.rollonthrottle.com/

BundyBear · Aug 18, 2004

Is your twistgrip an OEM Domino unit?

On my '98 you can dissassemble the twistgrip, slip the cable drum off the handgrip tube & flip it over. One way (I think marked "mcross"?) gives you linear response - ie each degree of grip rotation gives you the same huge change in carb slide position. The other (marked "enduro"?) is progressive - you must rotate the grip further at low throttle settings to get the same change in slide position than you do at high settings. In enduro position you must twist the grip further to get to full throttle.

Mine was in mcross when I got it. Flipping it over made it much more controllable.

Search

Search

Longer pull throttle assembly?

mboygood

PowerFiend

PowerFiend

mhambone

BundyBear

Similar threads

Register CTA

Recent Discussions

Recent Discussions