I've seen a few topics like this before and know that when pulling the cases off you can pull the lickstart shaft by mistake etc.
What I have is after putting it all back together the kickstart pushes through it's swing fine and returns to it's starting position however at the top position I can push it maybe an inch anti clockwise too and if it wasn't for the case I get the inpression I could push it further.
I can kickstart the bike and it runs fine, but can I leave the kickstarter like this? Is the spring correctly located?
What I have is after putting it all back together the kickstart pushes through it's swing fine and returns to it's starting position however at the top position I can push it maybe an inch anti clockwise too and if it wasn't for the case I get the inpression I could push it further.
I can kickstart the bike and it runs fine, but can I leave the kickstarter like this? Is the spring correctly located?
