This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

JD Tuner installation, FS570

T

t-rex

Joined Apr 2013
30 Posts | 1+
The Wet Coast
Got a JD tuner for my 2011 supermoto, and for the life of me, can't figure out where the white wire plugs into. The black wire is obviously the ground, but where does the white wire go?
If anyone knows, or has the installation directions, shoot me a PM or post up here.
Thanks!

download2_zps6027407c.jpg
 
It's been over 2yrs but I think that wire plugs into the TB harness. If I had seen this earlier I may have the instructions in my desk at the office If you cant get it figured by Monday PM me and I can send you some pix of it.
 
Last edited:
jetter

mine didn't have a white or a ground...just plugged it into the injector and it was good to go...
U can call them up, friendly and knowledgeable.
 

Similar threads

C
1998 husaberg 400 gas tank setup with mikuni lift pump.
Replies
5
Views
763
Charper90
C
W
2010 Fx450 crank no start after engine work
Replies
3
Views
477
waylon
W
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
418
rikschipp
R
H
For Sale 2011 Husaberg FS570 Factory Supermoto
Replies
1
Views
1K
Husaberg21
H
J
FS570-Mechanic Screwed Up or Bad Luck?
Replies
8
Views
970
Taffy
Taffy

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions