This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Husaberg 600 89-00

G

gamer3210

Joined Nov 2019
58 Posts | 8+
Warszawa
How is the timing gear to be installed because I do not remember anymore - it can be put on each side, I assumed that by putting on the upper sprocket and pressing it at 80Nm, it presses the one underneath and I gave it a distance from the side of the second sprocket
 
The timing chain gear is installed with the flat side facing towards the clutch cover.The primary gear is conical inside.It´s getting its final position when tightening the nut (as you have described).
 
Hi, I think the timing gear must be directed with the distance towards the clutch cover.
why ?
if I were to do the opposite, there would be no play between the sprockets and it would not be possible to install the timing chain
 
Happy new year. No that's incorrect.
When tightening the nut you will see that there is space.
Also when looking down from the camshaft... You will see the alignment with the timing chain gear.
 

Similar threads

C
1998 husaberg 400 gas tank setup with mikuni lift pump.
Replies
5
Views
761
Charper90
C
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
418
rikschipp
R
N
00' 501 Husaberg Timing chain problem
Replies
6
Views
1K
Charper90
C
G
husaberg fc 600 00 problem with 4th gear
Replies
3
Views
647
gamer3210
G
thorgan
'02 400 gearbox problems
Replies
6
Views
2K
Taffy
Taffy

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions