This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

How to get the rockerarms out?

B

boheme

Joined May 2005
137 Posts | 0+
North of Stockholm, Sweden
Hallo again!

This time I´m about to change the rockerarms for newer ones.

I´ve taken the valvecover off...

and now I´m about to remove the rockerarms. I have removed the two small screws at the side, but how do I get the rockerarmshaft out?

I´ve read the instructions but still its a clue to me...

I´ve got a 501 ´01

/boheme aka Rikard
 
I am going on memory here, so beware! I think that an indent in the shaft lines up with a cam cover bolt to positively locate the shaft. With the cam cover bolts out, the shaft will pull straight out, being just a bit reluctant from stiction provided by the rubber seals. You can use a threaded screw in the end of the shaft to get a purchase on it. Good luck!
 

Similar threads

F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
419
rikschipp
R
T
Another water pump seal thread (70 degree engine)
Replies
2
Views
2K
westerstroming
W
R
New To Me FE390 Maintenance Insights
Replies
24
Views
4K
robinasu
R
Taffy
New - improved carb needle 2004-2008
Replies
3
Views
2K
FlyingZebra
FlyingZebra
aaron
Intro - Hoge's Husa (Australia)
Replies
68
Views
17K
aaron
aaron

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions