need a bit of help with the fork seals on my wp 43 mm upside down forks. stripped them out ok but cannot get the new seal to go in far enough to get the circlip back in it looks like the seal support washer is holding the seal to high. question does this support washer more like a spacer about 4 mm deep and 1 mm wide go inside the seal lip or just lay underneath. without the spacer in the seal with drive in far enough but with that washer in it just will not go in even with a resnoble amount of encouragement.
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
