Hi, I'm getting Flash Code 06 on my Husaberg 570 2009 fault coming up;
My Manual says:
Possible cause:
Action:
Not to helpful any ideas please?
-Glenn
My Manual says:
Possible cause:
Action:
Not to helpful any ideas please?
-Glenn
Are you sure the manual does not say:
06 FI warning lamp (MIL) flashes 6x short
Throttle Position Sensor circuit A - input too low
Throttle Position Sensor circuit A - input too low
I don't see this in my manual:
If it is the Throttle Position Sensor (abbreviated to TPS) you can physically check it. Look on the "stand" side of the bike, the TPS is on the side of the throttle body and has 3 wires coming out of it.
Check the screws are not loose and that it has moved from its set position.
Unplug it and check the connectors look OK.
You could also try disconnecting the battery for a few minutes and reconnecting it. This resets error codes on “some” types of EFI computers. Not sure if it works on the Husaberg but worth a try.
Here is a picture of the TPS:
06 FI warning lamp (MIL) flashes 6x short
Throttle Position Sensor circuit A - input too low
Throttle Position Sensor circuit A - input too low
I don't see this in my manual:
If it is the Throttle Position Sensor (abbreviated to TPS) you can physically check it. Look on the "stand" side of the bike, the TPS is on the side of the throttle body and has 3 wires coming out of it.
Check the screws are not loose and that it has moved from its set position.
Unplug it and check the connectors look OK.
You could also try disconnecting the battery for a few minutes and reconnecting it. This resets error codes on “some” types of EFI computers. Not sure if it works on the Husaberg but worth a try.
Here is a picture of the TPS:
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
