This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Fe390 fuel pump replacement, other parts? Tips

E

Esto65

Joined Jul 2008
91 Posts | 0+
Whitchurch-Stouffville, Ontario, Canada
So as to not be different than everyone else, the fuel pump went on my 2010 FE390. As per the recommendations on this forum I have ordered a CA Cycleworks replacement. Before I start taking it apart this weekend I have a few questions:

1. Are there any other parts I should replace when I have the pump out?

2. Any tips / advice in replacing this part? My guide is the schematic in the Parts Manual. It does not look like rocket science but I might be missing something.
 
No rocket science, can only be connected one way. And you can disconnect the fuel hoses by carefully unhook the connectors using a small flat screwdriver. There are 4 slots where a special tool are to be inserted to disconnet them, but save the money.

Be careful with the screws though as you do not want a leak or damage you tank. Once I forgot the aluminium profile that holds down the air filter "bar" when I screwed back the top assembly into to the tank. The screws are long enough to pull through the plastics if that alu-profile isn't there. Tank ruined and I had to buy a new one. Can't be fixed due to difficult plastic... Don't do that stupid and expensive mistake.
 
Last edited:

Similar threads

K
AM fuel pump parts sourcing problems
Replies
1
Views
1K
o6550
o6550
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
418
rikschipp
R
T
no power to the fuel pump and lights on start FE450 2009
Replies
1
Views
501
tpayne
T
B
Spark for 2-3 seconds then nothing.
Replies
10
Views
572
mosierz48
M
B
Cranks, Fuel Pump Working, Runs on Ether.
Replies
2
Views
650
cheeseberger
cheeseberger

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions