This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Engine Shortcircuit not working

Berg650

Berg650

Joined Jan 2006
17 Posts | 0+
Unknown
Hi all first post for me, ok i replace the original speedometer in my 02 Berg, the old one, for a new digital Trail Tech ENDURANCE an the engine shortcircuit stop working anyone knows what need do for keep the Trail Tech and the button work.
I need reconect any cable
 
The Endurance is powered by a button battery, how could it interfere with the kill switch? Check that the connections at the ignition.
 
as froggy used to say: impossible(eerr) (but with a froggy type of accent to it)

regards

taffy
 
Impossible is a word to be found only in the dictionary of fools.

my boss on a friday at 3pm when i say we can't and he says .......

regards

Taffy
 
Welcome Berg650,

Here is the schematic for your Husaberg, take a look at it and yuour bike and see if you can figure out which wire may have become unplugged.

Let us know if we can help!

Regards,

Joe
 

Attachments

  • Wiring Diagram01-02.pdf
    45.4 KB
Re: RE: Engine Shortcircuit not working

LeFrog said:
The Endurance is powered by a button battery, how could it interfere with the kill switch? Check that the connections at the ignition.
Click to expand...

I dont think so my endurance work with a small battery
 
I see the electric diagram but what is the shortcircuit button is possible is start relay in the diagram??
 
Orange (OG) wire from ignition module to light switch. If this circuit is closed then it bypasses the ignition.

Look for a break in the orange wire. If no break, undo the connection the banana plug and ground it to the frame, it should close the circuit and operate as if you pushed the kill switch. That way you should know if you have a faulty ignition module.

Your Trailtech Endurance is powered by the battery?

Edit: the schematics has the orange wire as "OG" on the left and it becomes "OR" on the right side. You can't trust the Husaberg manuals. :roll:
 
Sorry my trailtech is a Panoram model but works very good, maybe slowly to take the speed.

Is posible the orange wire close the circuit inside the old speedometer, if is that i only connect the wire to the frame o some bolt?
 
I don't think the orange wire goes through the speedo, no. Just backtrack from the ignition and you'll find the issue somewhere between that and the switch,
 

Similar threads

A
2003 FE400E Digital Speedometer PCB repair
Replies
0
Views
211
Awingx
A
W
2010 Fx450 crank no start after engine work
Replies
3
Views
477
waylon
W
M
How do I find TDC?
Replies
3
Views
610
Taffy
Taffy
F
FE570 low idle issue, outside of the usual suspects! (I think)
Replies
1
Views
418
rikschipp
R
M
Rear lights issue/working the opposite way
Replies
4
Views
713
MrD
M

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions