This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Crankshaft width 501 -99 ?

J

jampe

Joined Nov 2007
396 Posts | 19+
Sweden Olofstrom
Hello again, more questions.
Another question about specifikations for my Husaberg FE 501 -99.
The crankshaft width when disassambled was 65.4 mm and i am not shure if that was ok.

Connection rod to crankshaft side clearance is 1.7 mm now and crankshaft width 65.4 mm with new connection rod and crankwheel deflection 0 !, on other thumpersis the connection rod to crankshaft clearance about 0.25-0.50 mm.

Its there anybody out there who has the correct specifications of my bike?

With best regards
Jampe
 
hi, i had a problem some time ago when i changed my conrod, no axial play of the crankshaft after re assemblying. i had to press the halves 0.5mm more to get a decent play between 0.2-0.7mm for ball bearings that is.

i don't think that if someone tells you a specific distance could help you, i would reccomend press just a bit as 0.2mm at a time and then assemble-measure and then do again if necessery.
this supposes that the bearings are of course correctly installed.
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions