I'm changing out the stator on my 400. How do I get the conduit off the old stator wires and onto the new one without tearing it up?
conduit(grommit) replacement
- Thread starter bksavs
- Start date
Unclip & remove the plastic shrouds off the charging wire spade sockets & shrink a piece of thin heatshrink over each to cover the sharp corners. You can usually pull the wires through the spaghetti one at a time but it is a bit of a struggle.
The woven spaghetti tubing should grow bigger in diameter if you compress it lengthwise, also helping. Pulling it once the wires are thru will return it to original size.
The woven spaghetti tubing should grow bigger in diameter if you compress it lengthwise, also helping. Pulling it once the wires are thru will return it to original size.
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
