Anyone who can measure their Husaberg 650 for me?

Finnar · Nov 19, 2014

Hi
My situation is that I have ordered a Snowbike kit for my Husaberg Fe 650 08 and right now I am in thailand and staying here until february.

The company who is building the kit need some measure on my bike.

Anyone who can do this for me?

I need these measures in millimeter:

1:Its the length from the centre top bolt of the rear suspension and to the centre svingarm bolt
2:And from centre of the svingarm bolt to the ground
3:The wide of the svingarm (see the picture)
4: How long the rear suspension is (The complete length of the damper)
5: How long is it from the centre of the svingarm bolt and to the center of the front sprocket axel

Thank you so much!

Finnar · Nov 19, 2014

Also need the measure between the frame and center of the front sprocket :

bushmechanic · Nov 19, 2014

Hi Finnar

i can measure these after work .. about 6 hrs from now..

bushmechanic · Nov 20, 2014

Hi Finnar,

I'll insert a disclaimer in case something is different on your bike to mine .. .it would be good if someone else could check a few things for you to verify.

1) is tricky will grab some lasers and **** from work and let you know tomorrow

2) depends on spring and preload .. approx 460 on std frame, someone else should also check it.

3) gap between swingarm for cases 106mm, each outer measures approx 50mm (mine is in the bike .. may not be 100% accurate someone with a swingarm out of the bike should check)

4) 403mm center to center

5) 65.6 measured with DRO to 0.001mm

6) centre of talon front sprocket to inside edge of frame as in your drg is 12.5mm will be about 0.1mm less with berg sprocket

bushmechanic · Nov 20, 2014

in this drg numbers are roughly within +/- 0.5mm

the 332mm dimension im not 100% on .. maybe someone can check that for you.

on my bike its 341mm but i raised the rear shock mount 9mm.

bigger pic https://www.flickr.com/photos/89798644@N07/15837724811/sizes/o/

Kayeffess · Nov 22, 2014

Finnar said:
Hi
My situation is that I have ordered a Snowbike kit for my Husaberg Fe 650 08 and right now I am in thailand and staying here until february.

The company who is building the kit need some measure on my bike.

Anyone who can do this for me?

I need these measures in millimeter:

Here are two of the measurements for you.

3:The wide of the svingarm
106mm engine space...(swingarm out of the bike) plus 50mm on each side for the bushings/bearings....total 206mm

4: How long the rear suspension is (The complete length of the damper).
450mmm (fe shock)

Ok

Search

Search

Anyone who can measure their Husaberg 650 for me?

Finnar

Finnar

bushmechanic

bushmechanic

bushmechanic

Kayeffess

Similar threads

Register CTA

Recent Discussions